Beer Rev Limiter Install

[CAT_SPEW]

Has anyone here had any experience installing these onto an RB25 with an aftermarket ECU? Are there any problems or anything that is needed to be done different?

I've seacrhed around and found a few sites with instructions

http://forums.freshalloy.com/showthread.php?t=162413

http://www.takakaira.com/asp/table.asp?id=849&cat=2

Cheers

[discopotato03]

The Haltech should have its own rev limiting device just can't remember if its fuel or ignition . Don't get busted with an afterburning exhaust , not good for turbo or cat .

That second link talks about Apexi PFC's being a piggy back ?

Cheers A .

[CAT_SPEW]

Yeh from what I know it does, but I'm not sure if it is fuel or ignition either. I think I could have bught a hand controller for the Haltech but I went with this option instead.

[CAT_SPEW]

Anyone know what the easiest way to figure out which wires to splice into on the Haltech would be? It's an E6K?

http://www.driftworks.com/resources/bee-r-...fitting,16.html

[BAMR33]

This pin out diagram may help if haltech is plugin (wouldn't have a clue myself), if not you'll have to get the pin out diagram for the E6K. You've got no worries with an after market ECU, as the signal is going out of the ECU. Just make sure you set the ECU rev-limit above the Bee*R rev-limiter always it might cause a complete cut of ignition and fuel and I don't know what would happen there, probably nothing.

red - power

black - earth

green - ignition

yellow - rpm

white - clutch switch for anti-lag or handbrake wire for launch control.

[BAMR33]

E6Kdiagram.pdf

[CAT_SPEW]

Thanks mate, I just found the same diagram but I can't find the CAS 1 deg and 180 deg wires on it??

[CAT_SPEW]

Can anyone find them on that diagram??