Jump to content
SAU Community

Recommended Posts

hey guys just picked up my car after 6months of sitting around whilst on defect! the car hasnt been tuned for 12months. the car is blowing black smoke faint on idle but when i dump it the smoke pops out! i have fmic, pod. the turbo has been replaced with a stock one! would it just be a matter of a new tune?? i can smell alot of petty! any ideas??

cheers adrian

Link to comment
https://www.sau.com.au/forums/topic/170222-rb20det-probs/
Share on other sites

"when i dump it the smoke pops out"

so when you you accelerate alot of black smoke comes out?

yep! thats right... when i put the foot down a puff comes out. and i can smell petrol! like more than normal. also its using alot more petrol than it normally does.

Link to comment
https://www.sau.com.au/forums/topic/170222-rb20det-probs/#findComment-3144450
Share on other sites

mods

gtr fmic

gtr pump

pod

zorst

i have been driving the car for 5days now...

i did have fuel pressure reg on there and eboost bt they are now off! will be going back on any day now! i was also told due to my turbo shitting itself there is oil in my cooler piping and on the bottom of the cooler! but this would cause white smoke wouldnt it? but im gonna book her in for a tune and c wat happens! mind u i have a rb25 turbo sitting waiting to go in!

cheers adrian

Link to comment
https://www.sau.com.au/forums/topic/170222-rb20det-probs/#findComment-3144822
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi All,    I have my BW EFR 8474 with a T4 split 1.05 rear housing. Rear housing is ceramic coated and drilled and tapped for EMAP take off.  Supported 520awkw at 35psi through the 8HP with ~5k rpm spare on the BW 127k limit. Ran a 9.98.    Turbo is one of the first that was released but only done ~3k kms.    Asking $2800 happy to negotiate. Only selling to upgrade.   Located Gladstone QLD happy to ship. 
    • Hi is the Toshiba sceeen still available?
    • Just wondering how come the hood was grinded down? 
    • I have no hard data to report, but I have to say, having driven it to work and back all week, mostly on wet roads (and therefore mostly not able to contemplate anything too outrageous anywhere)..... it is real good. I turned the boost controller on, with duty cycle set to 10% (which may not be enough to actually increase the boost), and the start boost set to 15 psi. That should keep the gate unpressurised until at least 15 psi. And rolling at 80 in 5th, which is 2050 rpm, going to WOT sees the MAP go +ve very quickly and it has >5 psi by the time it hits 90 km/h. That's still <2.5k rpm, so I think it's actually doing really well. (I edited this from a previous version where I stated 80km/h was <2000, but that was a false memory. If I am rolling at ~1700 in 5th and floor it, it will start making boost before it goes over 2k - which is a separate "experiment" leading to the same conclusion. Which is that the boost threshold is actually quite low. It's not fast there, obviously, but it certainly makes progress towards going fast, which is not what it's been like for a long while!!) Because of all the not-quite-ideal things that have been in place since the turbo first went on, it felt laggy. It's actually not. The response appears to be as good as you could hope for with a highflow.
    • Or just put in a 1JZ, and sell me the NEO head 😎
×
×
  • Create New...