Jump to content
SAU Community

Recommended Posts

Hey all,

I changed my spark plugs to NGK iridium (.8 gap), and am finding that at idle and down low the car seems lumpy.. Almost like I have put a new cam in it, also I have noticed the exhaust note seems to have more definition (for lack of a better word)..

The car seems to be running well, its just down low and off boost it feels weird.

Any suggetsions as to what this could be.. Is it just the new plugs (the old ones where very old a shitty), maybe a timing thing??

Cheers

Link to comment
https://www.sau.com.au/forums/topic/17047-spark-plug-question/
Share on other sites

Originally posted by Doctor

I changed from 7's to 6's yesterday and my god what a difference. Better start up, idle as smooth as power delivery more linear.

Then try going to 5's. I just went from a heat range of 5 to 6 and I dont like it! :D

I'll be going back down to a heat range of 5 again, so much smoother....

I found that once the car warmed up, idle was smoother, and that the plug didnt foul as quickly. It also significantly reduced the misfire at the 5000rpm mark seen by R33's with VVT (not that it applies to you :D ).

So in answer to your question, yes!

Temps were just the same, noticed no difference.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Re read everything that has been written about this in this thread.. Let us know if you're still confused.
    • This would be a new pump with new gears. I'm just unclear on whether it's a good idea to run more oil pump flow if you don't actually need said flow. Oil level is set a minute or so after shutting off a warm engine so wouldn't the high RPM oil level in the sump end up lower all things equal? Plan is OEM clearances, main concern in my mind is whether the OEM pump can keep up with the flow requirements of any additional oil coolers.
    • Don't do what I did, use a 300000km old housing with billet gears. The old pump probably was clearanced with saw dust, Edward Lee's special engine treatment sauce and a good odo wind back. I had oil pressure issues, then replaces pump with new housing, new billet gears and 2x track day later binned a motor due to other oil related issues due to a previous engine builder. Long story short, buy a M2 or 3 or 4 N55/S55/S58 and enjoy life.
    • Yeah. "New pump" does not have to mean "massive pump".
    • Well, can you still get an OEM pump, and by the time you're buying a Nismo/N1 etc, just buy another aftermarket pump. It's better to have the pump able to flow more if its needed, than for your pressure to drop off. At any point in time, you're replacing the oil pump in a rebuild. Aftermarket pumps are likely going to be a better economical choice, and they don't have any negatives, even if they can flow more.   Also, when you're saying "replace the pump gears" are you meaning leave a 25+ year old housing in the engine with unknown wear, and just put new gears in? As that sounds silly to me, especially if you do have that minute amount of wear, that means your new pump gears now have a little bit more clearance beside them, which means, whelp, you may not get to build a lot of oil pressure or make a lot of flow.
×
×
  • Create New...