Jump to content
SAU Community

Recommended Posts

Just wondering, hopefully in the not to distant future i wanna mayb get a slide high flow and some injectors and it should push the car to 250 to 275kw.

Anyway my question is who has got that amount of kws already in a r33 series 2 skyline? because at the moment i can fill my r33 to the brim and i can get about 350 to 400kms to the tank in normal city driving. At the moment my car puts out around 200kws, so yer if i get 250kws + what can i expect a tank of petrol to last for?

Cheers

Adam

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/
Share on other sites

  • Replies 104
  • Created
  • Last Reply

Top Posters In This Topic

Do you think you will pick up an extra 50-75kw at the wheels from a zorst system and some injectors?, what other mods do you have?...

no no sorry a slide high flow turbo and injectors.

I have a FMIC, power fc, 3in stainless steel exhaust, boost controller, pod, bosch fuel pump umm yer tuned to 205kws

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150485
Share on other sites

I am lucky to get much over 200kms per tank city driving for a series 1, you might get 250 - 300kms per tank...ultimately depends on how you drive it

damn!! only 200!! im deciding weather to do it or not because of the price of bloody petrol!

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150497
Share on other sites

hmm it really depends hw it was tuned, wot size turbo, boost etc.. eg.. say u had a T04e turbo or a 2530 then it would make peak power in the mid range eg 4-5500 rpm etc.. if u used a bigger turbo it obviously make the peak power later on in the rev range, say 6500+..

the above is a very broad generalisation so dont quote me. if u had a smaller turbo, you wouldnt need to rev it so much to make the peak power therefore MIGHT get "better" economy out of smaller turbo since it runs out of puff after say 5500rpm or so.. therefore you wouldnt necessarily rev it past that range everytime.. where as if you had a large turbo which made peak power later on the range, you would NEED to rev it that extra rpm to get that power, thus putting more stress and using more fuel. get my drift?

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150507
Share on other sites

hmm it really depends hw it was tuned, wot size turbo, boost etc.. eg.. say u had a T04e turbo or a 2530 then it would make peak power in the mid range eg 4-5500 rpm etc.. if u used a bigger turbo it obviously make the peak power later on in the rev range, say 6500+..

the above is a very broad generalisation so dont quote me. if u had a smaller turbo, you wouldnt need to rev it so much to make the peak power therefore MIGHT get "better" economy out of smaller turbo since it runs out of puff after say 5500rpm or so.. therefore you wouldnt necessarily rev it past that range everytime.. where as if you had a large turbo which made peak power later on the range, you would NEED to rev it that extra rpm to get that power, thus putting more stress and using more fuel. get my drift?

haha yer got ya lol! thats why i think ill only go for a slide high flow turbo...

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150512
Share on other sites

The tune does have a lot to do with it...but so does your right foot. Even if you go for the slide high flow you will find yourself pushing into the power curve more often to enjoy the extra power and use more fuel. It is inevitable :woot:

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150521
Share on other sites

The tune does have a lot to do with it...but so does your right foot. Even if you go for the slide high flow you will find yourself pushing into the power curve more often to enjoy the extra power and use more fuel. It is inevitable :woot:

haha true true! lol

but im reali just trying to get an idea of the fuel consumption just to see wheather for what i want the car for if its worth doing or not

Edited by Adz2332
Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150525
Share on other sites

R33 S1

I am getting around 350km @ 265 rwkw running really rich.. ( dodgy plenum leaning out a cylinder) will be over 400km per tank once new plenum and tune finished next week.

And thats being in boost quite a bit........ I could drive completely out of boost and get more!

I used to get 500km when I had 178rwkw.

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150539
Share on other sites

it all depends on the tune, i have about 250rwkw and can get around 350km's to a tank with normal driving, unhappy with that so i'm going for a re-tune next week

ok stupid question, remember i dont kno much about turbo cars, when i get a tune done for it can i basically say to them look i want a mix of good kws and good fuel milage? or what?

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150547
Share on other sites

how can you get that much fuel economy!!! how!? as i said im about 200kws and get 400 at the very very most

You dont hit boost :woot:

If you dont hit boost, economy is essentially the same regardless of turbo size.

Soon as you do get on boost though, it all changes as more power requires more fuel etc etc

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150665
Share on other sites

You dont hit boost :woot:

If you dont hit boost, economy is essentially the same regardless of turbo size.

Soon as you do get on boost though, it all changes as more power requires more fuel etc etc

ok i get that but when i go to boostworxs can i say to them look id lik a mixture between kw and fuel economy? or is that just a stupid thing to say? lol

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150674
Share on other sites

When you know how to tune your own car and you tune it "right" you get good economy.

You also do some hwy driving as well right? that would help a lil!

I have about 283rwkws and i get about 300-330 out of a full tank.. thats with alot of city driving and a fair bit of boosting :woot:

Link to comment
https://www.sau.com.au/forums/topic/170682-250kw-275kw/#findComment-3150677
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...