Jump to content
SAU Community

Recommended Posts

  • 2 months later...
  • Replies 66
  • Created
  • Last Reply

Top Posters In This Topic

Well madaz my coils were going fine until about 4 weeks ago entering the free way in the wet and hail i ended up sliding across two lanes of traffic straight into the side barrier and wrote off my car (with a bit of whiplash). Coils should still be all good though all though they are stuck on the wreck at pickles auctions.

Any one want to buy some good parts for cheap (PFC 800, hks evc boost controller 200, pillar gauge and mount 100 etc sadly)

Dont know whether i will be getting another line although if i do will defenitely be a gtr with a rwd switch.

Chris!! Thats f**ked up :) Hope you're ok now, wondered why we hadn't seen you for a while.

If you are parting the car out, how much are you after for the 3' dump pipe and cat (any good still)?

Also, the box for your pod, how much?

Cheers

Lee

PS (Won't be using the fuel pump, mine is fine, just noisy as where its located in the tank. Need to return yours :) )

Sorry to hear buddy. GTR prices are coming down a bit so i hope it helps you get 1 soon, so we go cruising again :)

PS: have u already taken the car up to pickles ? No way of you seperating the motor,box,ecu, loom ? Price ?

Edited by KISIN

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...