Jump to content
SAU Community

Recommended Posts

I am looking at investing in a sump extension. From what I gather Micks Metal Craft ones hold the most oil in them and seem to be praised as the best on the market. But, they cost a fortune and the engine needs to be out to install them.

What about the Trust ones? Is it true that they poke out the bottom and reduce the clearance of the car?

I know mods need to be done to the sump to fit them but can it be done on a hoist or is it s motor out job?

Are there any inherit faults with the unit?

Any help will be welcome.

thank you all in advance.

Edited by khezz
Link to comment
https://www.sau.com.au/forums/topic/172042-trust-sump-extension/
Share on other sites

We run the trust extended sumps and are happy with how they perform, haven't had any surge issues with it on.

It is pretty much an engine out job, you need to take the sump off, cut a hole in it and weld the extension on. Also comes with an extended pickup.

Hangs about 10cm lower than the standard sump but we have never hit it, even on tarmac rallies.

No real faults, they and the Micks ones are pretty much the same.

You still have a stock bottom end dude, and to this day, i still dont see the point when its only a band aid fix to a bigger problem with the RB's.

Also no point if your having the motor out, you might as well rebuild it if your doing that.

Just put 1 litre overfill into the sump before a track day or whatever, and you will be fine.

:P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...