Jump to content
SAU Community

Recommended Posts

"Are you ready for two full days of events, great food, excellent location, a spot of wine and catching up with all our members – miss the extravaganza at your peril !!

The fun starts Saturday 26th July at the Twin Service stations at Paruna (just north of Ourimbah) at 10am with the Touring Road Event. During the day this will include a Hillclimb at Ringwood and the day’s competitive activities conclude at approx. 3pm after the sprint event at Cessnock Aerodrome."

This sounds like a great event. I believe Dan mentioned it at the meeting on sunday. All the information I have for the moment can be found on page 7 of the CAMS Tale Spin newsletter here.

I intend to do the Saturday events and then cruise back, missing the dinner.

I'll post more when it becomes available.

Who's keen?

ps. We'll all need Level 2S licenses or higher for these events. :rolleyes:

Sounds good to me too. (and Kel, as always :P )

Dino, have you or Dan been in contact to get more info as it comes out?

Just a warning, we will probably require extinguisher in car and a bonnet tie down. Will need to see supplementary regulations to be sure.

They are just sorting out some details. It should only be a couple of days and the regs. and entry forms will be out.

Go here for the Safety Requirements. These are a bit tighter than the drive day standards and scrutineering is more in depth. :)

OK - this is cams requirements:

Compulsory vehicle and safety requirements include:

+ A secondary bonnet restraining device rope or strap is OK

+ A fire extinguisher I got one for about $50 from Race and Rally, mounted in bolt that holds back seat on - no holes required

+ A blue triangle indicating the position of the battery Either buy a sticker or just use blue electrical tape

+ Headlights covered with a transparent adhesive film (i.e. Contact) mmmm....i didn't do this one, if required the old cross of electrical tape over lights can do the trick

These can be applied to road going vehicles with a minimum of difficulty, and usually with no permanent modifications.

Competitors are required to wear:

+ Non-flammable clothing from neck to wrist to ankles

+ Helmet

+ And are recommended to wear motor sport specific gloves and shoes.

Basically the same as regular track day requirement for clothing

As Cams say, you can get the bonnet tie down and extinguisher in without having to modify the car, so its not as difficult as it may seem.

For the taping of headlights, I'll be using clear contact sheet cut to the shape of the headlights. For this event with a drive between the hillclimb and the sprint it'll save pulling the tape off and doing it again. :D

Understand bonnet thing..........................

understand fire and triangle things...........

clothes - helmut - gloves...........................

BUT

Originally posted by red900ss

........ We'll all need Level 2S licenses or higher for these events. :( [/b]

in s'tralian this would mean what?

Bonkers,

The licence that Dino is talking about is a racing licence that Cams issue. cost is approx $90 I think. It is required for events that are run under/by Cams that have competition invloved.

For more info go to www.cams.com.au

Dan.

  • 2 weeks later...
  • 4 weeks later...

C'mon all, heres a great chance for the club to make an entrance into the CAMs scene.

Its got it all:

Cruise

Hillclimb at ringwood

Motorkhana (mini dorifto)

Big dinner

Wine tasing

Weekend in the hunter

and not to forget, the commemorative t-shirt :)

And as long as we get 4 cars entered (=8 people) we can go for the club prize.

So who else is in?

Hiya FLIP, it's just a matter of filling out the form (goto www.cams.com.au and click on Licenses) and sending of the money to Melbourne. However, there's probably not enough time between now and the weekend.

Come out to Eastern Creek on thursday instead (no cams license reqd). :D



  • Similar Content

  • Latest Posts

    • Hi guys, Sorry to butt in and take it slightly off course, although still on the VCAM subject.  I had VCAM put into my Tomei 2.8 bottom end and I struggle to take off because the engine has very little torque caused by VERY low dynamic compression at 60psi. But once off the mark and especially on boost, the engine rev happily all the way to 8000rpm and makes 630hp at 20psi of boost on E85 at the rear hubs. Has anyone had any similar experience or any suggestions on what might cause this low compression at low rpm? I am in the process of converting it into a 8hp transmission and with this low torque, the engine would not even stay running until the throttle is opened to more than 30% and then I loose all vacuum. 
    • Last year I got a set of MCA street coilovers for my turbo Forester after my son hitting a concrete gutter/wall on a small bridge causing the whole drivers side suspension to get bent because the rain just made the car slide out I love them, I think they were $2400. even had a hiccup of have the wrong hub configuration (my fault) so got onto MCA and they sent the correct shock ends overnight parts from QLD, for free!  I was very impressed with their customer service and quality of the product  
    • They've had some weird failures on their brake actuators. One of them was because they added some kind of lubricant to the factory fill brake fluid that aftermarket brake fluid didn't have so it would affect the seals. Another was just mysterious, probably internal corrosion or something eating away at Prius brake actuators. Parts alone for those are a few thousand USD so not a cheap fix.
    • Selling a genuine Nissan Skyline R33 Coupe 8-Pin Power Window Master Switch Part No. 25401-26U10 Price $300   IMPUL Gear Knob – Rare JDM Upgrade Upgrade your interior with this genuine IMPUL gear knob – a rare and stylish addition to any JDM build. Premium quality, perfect fit, and an authentic Japanese touch for your ride.  Price:$300 Nissan Skyline R33 (Series 2) Sedan Tail Lights Immaculate Condition OEM JDM S2 a pair of OEM Skyline R33 Series 2 sedan tail lights in excellent condition. These are becoming harder to find, especially in this state. Price:$900   Located in Melbourne (Western Suburbs) – Shipping available Australia wide at buyer’s expense. DM if you need anymore details.  
×
×
  • Create New...