Jump to content
SAU Community

Recommended Posts

Puzzled,

I should take this one back to the autoelec, who I think created the prob.

When I first pruchased the Car late 2002, I had a FM modulator installed to the Stock Sound. I didn't use the A/C or Climate control for a couple of days but soon after noticed that my C/Contol Modes were wrong and was defaulting to the Floor instead of the Dash.

The Thermostatic control had gone a miss also with 18 degrees as cold and 19 onwards as hot with nothing in between. Freezing or sweating was the choice.

Checked some websites for diag instructions and found that 2 of the C/Contorl sensors were dodgy, one being the light sensor in the dash.

How does it sound?

Is this something I can fix?

Is this a costly autoelectic job instead?

Thanx in advance!

RJB

I have noticed my climate control has a mind of it's own. Depending on something (phase of the moon? I really don't know) it will start on floor, vents or half and half, then change later. It may have something to do with where it senses the biggest temp difference or something. It's heat settings seem to work ok though, and if I don't like what it defaults to then I over-ride it.

If you do the air con diagnostics, remember to do it in the sun or shine a light onto the light sensor or else it will come up faulty.

I'm guessing that your interior temp sensor wasn't reconnected. My friend had the exact same symptoms and was fixed by connecting the interior temp sensor.

If it is heating (not just mixing a little warm air in), it will warm the footwell on 'purpose'. This, as far as I know, is normal - pressumably so you don't get a face full of hot air. As the ambient temperature rises in the vehicle it shifts the air flow back up to a combination of footwell and face vents and then eventually just the face vents.

  • 1 month later...

RJB

I also have the exact same symptoms as previously descibed. Did you end up finding the interior sensor as this one seems to be faulty according to the diagnosis on my car. How much did it cost to fix and is it a diy job?

Also does anyone know what the three calibration readings are on the R33 in diagnosis mode 5?

Check behind your dash..there is a hose that goes to that little 2cm x 1cm vent not far from the steering wheel on the dash.. in there there is a little temperature sensor - its possible that is faulty or sitting in the wrong place.

It could even be possible somebody has not screwed it correctly back into the dash plate where it meets that reading vent, and its sitting there reading from the plastic or something like that.

Originally posted by surreal

If it is heating (not just mixing a little warm air in), it will warm the footwell on 'purpose'.  This, as far as I know, is normal - pressumably so you don't get a face full of hot air.  As the ambient temperature rises in the vehicle it shifts the air flow back up to a combination of footwell and face vents and then eventually just the face vents.

I too have noticed with the cooling of the weather the climate control tends to be on the floor vents more often than the face vents. If the trend reverses again this summer I will presume that all is normal.

Mine is exactly the same in terms of heating from the footwell up. To be honest i thought it was obvious that if the car was to be heated, the hot air would come from below... and vice versa with cooling. Not trying to be a smart a$$ or anything but that's just how it should be. (Doesn't do it when only minor changes in temp are required though.)

Adrian

Originally posted by predator666

Check behind your dash..there is a hose that goes to that little 2cm x 1cm vent not far from the steering wheel on the dash.. in there there is a little temperature sensor - its possible that is faulty or sitting in the wrong place.  

It could even be possible somebody has not screwed it correctly back into the dash plate where it meets that reading vent, and its sitting there reading from the plastic or something like that.

So thats what that hose is. I found mine to be disconnected last time i pulled the dash off...

Should stick it back on then!

man i think climate control is such a gimmick .. it doesnt' work .. cause the cooling or heating is at the front ... takes too much time to reach temperature ... so i just manually set the temp myself ... the thermo couple is at the front too .. make sure that is clean for the best results i guess ... actually for BEST results .. place it where u want it to be the temp u want!!! :)

  • 2 weeks later...
Originally posted by predator666

Check behind your dash..there is a hose that goes to that little 2cm x 1cm vent not far from the steering wheel on the dash.. in there there is a little temperature sensor - its possible that is faulty or sitting in the wrong place.  

It could even be possible somebody has not screwed it correctly back into the dash plate where it meets that reading vent, and its sitting there reading from the plastic or something like that.

this was the exact problem i had. fixed my crazy aircon. it was all over the place. and now when i turn it on it starts in the footwell and then moves to the dashvents and behaves alot better.

  • 2 weeks later...

i could be wrong...and normally am but i normally do mine so im pretty sure i am right this time...;P

turn off the aircond. then turn off the car..start the car back on and immediatly after the car starts, hold the OFF button on the aircon system for 10 seconds or at least until u see the whole display light up.

then press the temp UP(red one) to begin diagnostics. the first is the 20's and then 30's and etc...

im not sure what 30's and onward mean but on the 20's.. as long as it says 20, its fine. if its 25, it means the photo sensor on yr dash right near the windscreen is messed...clean it up and give it another go...that normally works for me

laters

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh... literally every time i jump on a forum, see an instagram post or see an engine bay at a car show, i get an idea and add it to my 'to do' list. So what started off as, hey can u just make a couple of intake hard pipes because my dumbass bought the wrong apexi kit, blew out into a 2 week job including braided brake lines & custom bash kit for the front lip haha.  Getting Luke from A4E engineering to make a full custom exhaust with a controllable aes dump valve so i can actually switch between quiet and loud, because right now its just loud all day every day. Then after that go and get the tune redone flex e85 & 98 as i get bugger all milage from e85, makes going for longer drivers difficult
    • Car looks clean as. You ended up getting quite a bit done 馃槀  So what's the plan for the exhaust? 
    • The only Neo rods that were any different to any other RB25 rods were the DET ones, and they were the same as RB26. Here is a Neo DET rod. O5U part number visible. Here is a post in a thread here on SAU with evidence from someone who has done this before. There are photos in the thread of normal RB25 rods.  
    • Sure, but why assume that will be the case forever? And why assume you'll be able to do an oil change to swap back to a stock drain bolt before that happens? And does it even matter when I change the oil at fairly short intervals? Life can be funny sometimes and unexpected things can happen. Like breaking a collarbone so you can't do any work on your car for a few months but the oil change is due so you have to take it to somewhere and hope they don't do something stupid like stacking the new drain plug washer on top of the old one.
    • Do u know how to identify the rods are rb25 or neo ones? Can u look into the pics and tell me is they de or de neo ones. Its confusing becoz my motor has de neo head but block is 25de 75t, so really confusing me about rods, crank.
  • Create New...