Jump to content
SAU Community

Recommended Posts

item: 1996 r33 series 2 in silver with sunroof

location: brissy northside

price: $21000 offers and critcisms welcome

reason selling: losing licence for 6 months and want 4x4

post-30088-1182658065_thumb.jpgpost-30088-1182657670_thumb.jpg

post-30088-1182657768_thumb.jpgpost-30088-1182658172_thumb.jpg

extra info: rb25det, decompressed hks head gasket. gt3566spl turbo,hks exhaust manifold, tial sport 44mm external wastegate, stainless dump pipe, Greddy intake plenum, hks 740 cc injectors,q45 infinity airflow meter, are bar and plateintercooler, blitz air filter, custom stainless steel intercooler pipes and cold air induction. high flow turbo back zorst, apexi power fc with hand controller, apexi avcr boost controller,full built heavy duty clutch, twin in tank high pressure high volume pumps with all fuel wiring upsized and upgraded, malpassi fuel regulator, 18 inch work ls105's, genuine leather momo steering wheel, sony mp3/ipod ready mp3 player, alpine type r 6" in front, mtx 6x9's in rear, CYA33 REGO PLATES, everything engineerd for 30psi.

car comes with the shiny wheels

pm or thread it

serious enquiries [email protected]

Edited by aussiboir33gts
Link to comment
https://www.sau.com.au/forums/topic/173976-96-r33-series-2-low-11s-440-bhp/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Exhaust end of this month, and then tune after that whenever there is availability. Still tossing up between a pure 98 tune or a flex 98/e85 combo.  The (lack of) milage in e85 isnt great. Start to get anxiety if i go for a long drive and there arent any united servo's nearby
    • I mean I can be OCD'y but this is really over the top. At that point why not just run a full wideband fuel controller? Especially if you run 3 widebands. The system works pretty well, which is trimming low load stuff to be within a few percent of the base map. Pre-engine _change_ the base map was only 1-2% off, depending on ambient temp, elevation, etc. Under load the LS is really very straightforward to tune, enough that a wideband closed loop would be overkill. If I really cared (and I hope I don't) I can always just go back to the MAF system the car actually came with. Which does all those nice calculations for me (temp, altitude, etc), now that you can buy 102mm MAF's that do not cause restrictions.
    • Good afternoon Team , just a quick update on performance mods  Current Mods list (Installed) HKS - Power Editor (Came with the car) looks to be some kind of boost controller RV37 Skyline 400R (SKYLINE) | FUJITSUBO  - Cat Back  RV37 Skyline 400R (SKYLINE) | FUJITSUBO  - Front Pipe AMS  - INFINITI Q50/Q60 RED ALPHA COLD AIR INTAKE KIT AMS  - Performance Heat Exchanger Intercooler Not Yet AMS Alpha Performance Full Race Down Pipes  - to be installed in May 
    • I'd be installing 2x widebands and using the NB simulation outputs to the ECU.
    • Nah, it's different across different engines and as the years went on. R32 era RB20, and hence also RB26, the TPS SWITCH is the idle command. The variable resistor is only for the TCU, as you say. On R33 era RB25 and onwards (but probably not RB26, as they still used the same basic ECU from the R32 era), the idle command is a voltage output of close to 0.45V from the variable resistor.
×
×
  • Create New...