Jump to content
SAU Community

Recommended Posts

I thought I would start a new thread as there is a lot of talk about a meet up point which is getting confused with general chat about the day.

Rather than go back and forward with suggestions please consider the following:

For those who want to cruise down to Wakefield together, I can meet at Casula Bunnings car park at the cross roads from 6:00am leaving at 6:15am SHARP.

This is located where the Hume Hwy splits into Camden Valley Way and Campbelltown Road. The big white building in the centre of this map: Map

I think this is a good spot as it is near the M7 and M5 so is convenient for those coming from most parts of Sydney. It is also easy to get on the Freeway and head to Goulburn from this point.

Post or PM if you want to meet up from here.

+1

615 not too late to leave? Thought the track opened at 8am :)

I does but you will have rego, drivers meeting, etc. My guess is you won't be on the track before 8:30 at best. Getting there earlier just get you a better garage.

+1

615 not too late to leave? Thought the track opened at 8am :dry:

For the Circuit Club day at Wakefield we met at 6:30 am and left at 6:45 stopped for fuel at Marulen and arrived right on time for their 8:30am registration.

If we leave at 6:15am we should be there by 8:00am driving the speed limit.

I don't think that track time starts until 9:00am anyway.

+1 more.

I would have thought the servo would be a better option to meet at, as i usually fill the car and jerry can before the track day.

I usually fill up the day before so I don’t have to worry about chasing fuel so early in the morning.

We will stop at Marulen BP which is about 20 to 30 minutes or so before the track. This will give everyone a chance to fill up with premium (BP Ultimate 98 ron) and get snacks and drinks if necessary. There is even a Hungry Jacks and a Diner if you want breakfast.

This way everyone gets to the track with a full tank of premium.

cant wait to pop my track cherry and meet you guys again. Have only met handful of you once at the SAU dinner at the mean fiddler but was too pissed to remember any of you. Do remember only adam, nick and jess from that dinner though am not sure if it would be vice versa :thumbsup:



  • Similar Content

  • Latest Posts

    • Actually,  just remembered there should be info in the threads (somewhere) about swapping to a manual steering rack and deleting power steering all together. 
    • Also had a look at the Nissan JP website looks like the 400r has a slightly shorter ratio than than the regular V37 3.133 VS 2.937 which from a guy who has driven both 3.69 vs 4.11 ratios in the S15 is bugger all. Seems that the AUTO Z runs the same ratio as the 400R but can't find any info as to if its an open or LSD? More often than not the auto LSD is open
    • Do not replace the power steering lines with this stuff. If it's anything like the Chase Bays stuff it will leak and be worse than stock. The reason why the reservoir is on the LH/passenger side of the car is because that's just where the reservoir was most convenient to fit. Don't overthink this stuff. The intake/cold side of the engine is pretty busy on these cars. And again, the hardpipe is designed to be a janky power steering cooler. In theory you can replace it with a real power steering cooler but that's really only for track use where boiling the fluid is a distinct possibility. Start with the low pressure lines feeding the pump from the reservoir. Make sure there isn't a bunch of junk in the reservoir filter. Be careful to not get ATF all over the engine bay. I hate dealing with ATF spills, you can clean it up and the slightest crevice will still release more oil that can still drip over time. You also want to inspect for leaks before you make a mess and can't tell what happened. Most likely you have a leak somewhere that is allowing fluid out and air in. Failing that it's allowing air in but not fluid out. Only place I can really see that happening is on the low pressure side because the pump will pull a slight vacuum to draw fluid in. Everything after the pump is high pressure or lower pressure, approaching atmospheric by the time it returns to the reservoir.
    • I did a skidpan night at SMSP this week, it was much cheaper than $350. But yeah, you need to slap an LSD in that thing.  I put an OS Giken in the 370Z and it's f**king MARVELOUS even compared to Nissan's viscous LSD. So you're saying it's free now that it's a housing estate? 😂
    • Nah, the car seems to run exactly as it did prior, in saying this it does "seem" to be better down low, like more eager to rev, but that may be 100% placebo effect from intake noise But, I'm not worried about it at all, in the end it is a fairly low compression NA engine that has a well shrouded intake,  if it is getting hotter IAT I cannot notice anything negative performance wise from the seat of my pants thrashing it about on the street or sitting in traffic, so meh, car now now makes induction noise so I'm happy
×
×
  • Create New...