Jump to content
SAU Community

Recommended Posts

  • Replies 453
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Interlooper/SNISMO:

we are meeting Eatan8 on torquay rd/Surf Coast HWY (see map).

if u guys like, pm me your mobile numbers, when we leave the meet point near avalon, i will msg you that we have left and we should arrive in this location (map) within 25-35mins (traffic depending)

let me know if this helps you guys out, i know you dont wanna double the travel distance as you live on the side of where we are travelling. so let me know.

post-31466-1187398785_thumb.jpg

Edited by cheez
Interloper/SNISMO:

we are meeting Eatan8 on torquay rd/Surf Coast HWY (see map).

if u guys like, pm me your mobile numbers, when we leave the meet point near avalon, i will msg you that we have left and we should arrive in this location (map) within 25-35mins (traffic depending)

let me know if this helps you guys out, i know you dont wanna double the travel distance as you live on the side of where we are travelling. so let me know.

yup, that location suits me fine. Thats where i met the group on the last official cruise.

well interloper, send me ur mobile number and as with eatan8 ill msg u when we on our way there so your not sitting around waiting too long.

I'll join in here as well. PM sent.

just a little note for those who would like to head up with myself and dilmah we will meet at stud park shopping center in the warehouse carpark at 6:45ish and will leave sharp 7am to make it for the pre meet at campbellfield kmart.

thanks

Ash

okily dokily :)

Sure, just agree to pre-pre-meets.. :<

You know you have to pick up the other 'noob' too? So.. set alarms for 4am? :laughing-smiley-014:

Edit: Might not have to pick up other noob. :>

Edited by rh1n0
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Adjusting the idle screw is usually (emphasis on usually) just covering up deeper issues. Stuff like the cold start valve not closing properly. Throttle shaft seals on the way out. Coolant temp sensors getting out of spec. Coolant temp sensors especially can be a bear to diagnose because they can fail subtly. My dad just spent weeks chasing down his high idle. He cleaned the coolant temp sensor and everything but the resistance curve just drifts over time and if it's been 20+ years they also get super slow to respond as well. Has a massive effect on fuel economy as if it's off the ECU is going to run richer and command high idle for far longer than it should otherwise.
    • How old is the battery, it's more likely your battery is on its way out.
    • I reckon you'd get 90% off. My washer doesn't get between spokes very well. Haha! I love my Gerni!  Argh! Steam cleaning has its place for sure.
    • Hey all, I did a voltage test with the car (video attached) not running for 3 days. And here is some interesting stuff: - Battery voltage is 12v (I had the key in the ON position) - Drops to 9.76v while cranking then quickly goes up to 14.5v - You will notice there was a sorta slow start but not as slow as it usually is. - Idle surprisingly was better at just over 1,000rpm instead of 1,100 rpm. - I turned on the A/C, radio and headlights in the video and the voltage remains the same - I haven't cleaned the grounding wires on the chassis yet, that's next. - Battery drops to 12.6v when I turn off the car and wait a bit Seems like I might have a parasitic draw? I do have an immobiliser system which does drain the battery more of course but was wondering if there is anything else I should be looking at fixing? Does the ground wires on the chassis have anything to do with the low 12v?        SAU.avi
    • My lord that is some low oil pressure as minimum in the manual! I guess the big part will be seeing how it changes as the engine gets more spirited use.
×
×
  • Create New...