Jump to content
SAU Community

WTB - Springs

foshan

By foshan,
in Wanted to Buy

 Share

Recommended Posts

foshan Enthusiast

foshan

Posted
Posted

As the title suggest im looking for some aftermarket springs for the r33 gts. I currently have standard suspension but i dont want to lower it too much cause i have a 400r front bar which already is very low. So anything b/n 1 and 2 inches would be good.

Also i dont want to spend more than $500 so coilovers are porbably out of the question. I think king springs would probably be the best option.

PM if you have anything to sell.

Cheers

Luke

Link to comment
https://www.sau.com.au/forums/topic/17566-wtb-springs/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      RB20DET lean on cold start

      By GTSBoy · Posted

      You shouldn't need to massively fatten up the mixtures for cold conditions. For one thing - 0°C is not that cold. For another, the Haltech will be using the IAT sensor to tell it how dense the air air, and calculate the correct amount of fuelling. Then the cold start enrichment is added as a % on top of that, so it should scale with the main fuelling. You might also doubt the IAT sensor at this time. You're not using one from an RB26 are you? Using a nice Bosch sensor or similar? Happens. Some wideband units take great pleasure in killing their sensors. Put another wideband in the tailpipe and compare. Or just swap the sensor to a brand new one and see.
    • MidnightR32
      RB20DET lean on cold start

      By MidnightR32 · Posted

      Oh, my misunderstand. When the car was running, it sounded ok, but if I gave it any gas it wanted to die but caught itself afterwards. It's very different from how it was a couple months ago when it was warmer outside. The logs show that the AFRs are better during, what I assume, is warmup enrichment. Because it's cold, and air is more dense, should I work on the enrichment bit?
    • A31Skyline
      Rb20e and RB20DET parts

      By A31Skyline · Posted

      yess of course im not using 2nd hand parts from my spare engine, but the place where i live is hard to find parts for the RB20DET ,but for the RB20E is everywhere including new ones and a lot cheaper ,because for the RB20DET you have to order it overseas to get one and it cost a lot of money 3x the price to be exact. so i ask this topic because if i can use the new ones but for RB20E is it compatible or not. if not im screwed haha, not totally screwed but i have to save a lot of money first before i can begin repairing my engine, thanks for the information before.
    • MidnightR32
      RB20DET lean on cold start

      By MidnightR32 · Posted

      Unless my sensor just died, was only a couple months old, I strongly believe it didn't. How can I test it? I never mentioned it being 20:1+?
    • GTSBoy
      Rb20e and RB20DET parts

      By GTSBoy · Posted

      Well, you wouldn't use 2nd hand bearings out of another engine anyway....so just buying the proper bearings is obviously what you're going to do. The crankshaft would be common. The conrods might be common. There is essentially nothing else you would be able to use.
×
×
  • Create New...