Jump to content
SAU Community

Recommended Posts

Hi all,

I plan on doing a number of track days and Dutton West. Now I have a R33 GTS25t with minimal mods. I plan on changing the suspension and brake pads however I would like the engine to be almost indestructible.

I don't intend on winning anything at all, just wish to have fun with minimal to no break downs. At the moment I have 155rwkw's and would be happy with say 190-200.

Is it possible to create a much much stonger engine and associated parts that are capable of handling 200rwkw's? If so, what needs to be done and how much would it cost. At this point my budget would probably extend to $10k including around $2.5k on suspension.

Any help will be muchly appreciated.

Cheers

Will

Yeah, agree with manwhore.

Possibly concentrate on improving oil control to stop starvation of the bottom end.

And yeah, oil cooler, good maintenance, and also some gauges (boost, oil temp + pressure, water temp, perhaps EGT or wideband also) to keep a close eye on things.

Frequent fluid changes and making sure nothing overheats should keep it running pretty much indefinitely Id think

just be careful and make sure you overfill the oil by at least a litre and make sure to use good quality stuff... I have about 200rwkw off the stock turbo and just spun a bearing during a track day at Sandown... I will be doing all the oil control mods when its rebuilt this time... restricting the oil supply to the head, running an external drain, N1 oil pump, oil cooler etc

see thread here http://www.skylinesaustralia.com/forums/in...173225&st=0

regards to suspension I run the Bilstein works kit listed in the group buy section of this forum... is great on the road and the track, maybe a bit soft for tracks like Phillip island where you would be better off with some super hard Teins or the like... its the stock diff that I hate, doesn't allow you to put the power down out of some corners, making you use a higher gear to stop it single spinning

brakes I run Ferodo DS 2500's with RDA slotted/dimpled rotors and high temp fluid, no fade after 6-7 hot laps of Sandown

I don't have any problems with cooling, stock radiator is a good bit of gear just make sure its flushed and working 100%

that's about it, people might tell you its not much power but its enough to run some respectable times and frighten a few M3's. WRX's Evos and the like... providing you can drive;)

regards to suspension I run the Bilstein works kit listed in the group buy section of this forum... is great on the road and the track, maybe a bit soft for tracks like Phillip island where you would be better off with some super hard Teins or the like... its the stock diff that I hate, doesn't allow you to put the power down out of some corners, making you use a higher gear to stop it single spinning

Thanks Nick, I was speaking to a person about it and they suggested I get a new diff. They changed the suspension first and then the diff. Their opinion was that the diff provided the same sort of traction gains as the suspension upgrade.

That leads me to my next question, what diff should I go for and how much do they cost.

Cheers

again.

personally I was looking at the Nismo range in either a 1 or 1.5 way... the GT Pro would be good but its a bit expensive... you can pick a Kaaz diff up for about a grand on these forums which seems like good value for money... also Cusco and Tomei make diffs available through Nengun or Greenline... I was only leaning towards the Nismo as I know they are at the more streetable end of the market... however many of the diffs you can customise with different preloads so you have lots of options!

no point in having more power if you can't put it down... you might look cool on the street but in competition its just embarrassing lol

what tires will you be running?

what tires will you be running?

I currently have a new set of Goodyear F1's. 235/45 all round. Not bad on the road, how do you think they will handle on the track?

Previously I had an extremely good set of Bridgestone Potenza's, which I believe were extremely good on the track, in fact a GTR on one of the best motoring videos had the same set and the commentary made special mention re the tyres.

Cheers and thanks for your help.

The Goodyear Eagle F1's are a very good set of street tyres. I reckon you should stick to these for a couple of track days to learn the ropes of circuit driving and find the limits of these tyres.

Then, if funds permit try a set of semi slicks. You will then be able to notice the improvement and differences between both and easily shave off a couple of sec's off your lap times.

Back on topic, if your car is in good nick, it should perform very reliably on the track. Main things are just oil control issues as already stated and over-revving. Especially with regards to rev-matching, I know people who drop gears way too early and rev match in the 8000s :D

The Goodyear Eagle F1's are a very good set of street tyres. I reckon you should stick to these for a couple of track days to learn the ropes of circuit driving and find the limits of these tyres.

Then, if funds permit try a set of semi slicks. You will then be able to notice the improvement and differences between both and easily shave off a couple of sec's off your lap times.

yeah thats not a bad idea... you probably won't be finding the limits of the tires on the first time out... hopefully hehe;)

The only problem I have with my car is that it has boost spikes. I haven't made any changes to my boost settings however when close to redline it will suddenly go from around say 6 psi to 10 or 11.

I realise this is something I need to fix before I hit the track. I'm obviously no expert so need your advice. Do I simply need a boost controller or that plus a new ECU or just a new ECU?

Cheers

I run with a SAFC (to lean out the mix, they run really rich off the stock ecu with the boost up) and an electronic boost controller... but if you can afford it a full standalone like the power fc is a better bet as you can adjust ignition timing... even then its a good idea to run a EBC as it holds the boost steady and has a few other useful functions... don't know why your boost is running away in the top end... 10 or 11psi isn't dangerous but spikes aren't generally a good thing... I use 10.5psi on track

Smurf that is the extact setup I had in my gtst when I tracked it. I ended up with around the 200rwkw mark (on a safe tune for track) and it survived without issues for years when I was running on street tyres....

Engine wise....FMIC, ECU (in my case Wolf but PFC's are around the same cost these days), stage II highflowed std turbo with ported exhaust manifold, always ran castrol edge 10w60, oil cooler. Oh and a good free flowing exhaust.

Apart from that I recommend upgraded clutch (if you haven't done so already) and upgrade the diff. Also run good brake pads and fluid together with braided lines. Also at least have an oil temp, boost and oil pressure gauges so that you can keep your eye on things.

In all the years I ran this setup I never opened the block and the only issues I had with it were the coilpacks breaking down and the std exhaust manifold cracking. At the end of the day as long as you over service the car and have a good base to start with it should last.

If you want a quick track car.. it may be best to on how to get the most out of the power you already have..

As said before..

-Oil cooler/feed etc.

-Front mount..

-Full or semi slicks..

-Coilovers..

-Front and rear strut and sway bars..

-Let the engine breath and a full mandrel bent exhaust (not just cat back) and a hi flow cat and a better flowing dump pipe and exhaust mani

-And strip th shit out of the car (or save weight ie. Carbon fiber bonnet, fiberglass front quarter pannels, Seats, exhaust as well as the usual stripping of non-essential interior parts)..

-Diff..

-Short shift kit..

-A lightened flywheel is a good idea for a track car too..

-Brake pads and perhaps new disks

All these enhance the car you have without going overboard on power.. theres no point in having power if you can't use it wisely.. so focus on using the power you already have in the best way..

and always use good fluids.. and replace frequently..

Smurf - having just had a play over west the last thing you want is real stiff suspension. The quick way around barbagallo is over the curbs through those esses holding it flat from turn 1 to the sweeper and you won't do that with something too stiff. And the inside line down the back straight is bumpy as hell. And Collie and AHG aren't stiff set-up places either. So getting the set-up right seems pretty important over there. I believe there is a place over West called Wilkinsons that seem pretty switched on for set-up stuff.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah, the latter. No diff should have a centre replaced without checking clearances because its unlikely to be the same as whatever came out. Not that that stops most people just checking a new centre in
    • Major thread necro but how bad of a job is it to DIY? Looking at it online it looks like if you reuse your ring and pinion as long as those are in good condition it should be fine to just pull the axles/front cover and replace the diff that way? Or should I be replacing everything and doing preload measurements/gear mesh testing like the factory service manual mentions for the rear diff?
    • in my list I had the R33 GTR as the best Skyline. Infact I had all GTR's (33>34=32), the NSX, the GTO, the 300ZX, the 180SX, the S15 better than the FD RX7. I had the MR2 and the A80 as 'just' better. I also think the DC5R Integra looks better but this is an 01 onwards car. I also think the FC>FD. It's almost like aesthetics are individual! The elements @GTSBoy likes about the FD and dislikes about the 180 are inverse in my eyes. I hate the rear end of the FD and it's weird tail lights that are bulbous and remind me of early hyundai excels. They are not striking, nor iconic, nor retro cool. The GTO has supercar proportions. I maintain these look much better in person (like the NSX) especially with nice wheels and suspension which is mandatory for all cars pretty much. Some (or all) of these you have to see in person to appreciate. You can't write a car off until you see one in the flesh IMO. Like most people we probably just like/dislike cars which represent certain eras of design or design styles in general. I also think the 60's Jag E type looks HORRIBLE, literally disgusting, and the 2000GT is nothing to write home about. FWIW I don't think the Dodge Viper Gen1's have aged very well either. You can probably see where I rate bubbly coupes like the FD. I know we're straying now but the C4 and C5 absolutely murder the Viper in the looks department as time goes on, for my eyes. Wouldn't surprise me if people who love the FD, also love the MX5, Dodge Viper, Jag E Type, etc etc.
    • I used to hate R31s, and any of the other Nissans that led up to it, and any of the Toyotas with similar styling, because of the boxiness. They were, and remain, childish, simplistic, and generally awful. I appreciate R31s a lot more now, but only the JDM 2 door. The ADM 4 door (and any other 4 door, even if they are unique compared to our local one) can eat a bowl of dicks. The Aussie R31 is also forever tarnished by their association with stereotypical bong clutching Aussie R31 owners of the 90s and early 2000s. I think the Nissans of the 70s (other than 120Y/180B/200B) are far superior looking to the 80s cars. The 240K era Skylines are boss. The same is broadly true of Toyotas. Hondas don't ever register in my thinking, from any era. Mitsus are all horrid shitboxen in any era, and so also don't register. Subarus are always awful, ditto. Daihatsus and Suzukis also don't generally register. They are all invisible. I think the SW20 MR2 looks fiddly. The 3000GT/GTO is like that but way worse. Too many silly plastic barnacles and fiddly gimmicks ruined what could have been a really nice base shape. Kinda-sorta looks like a big heavy ST165 Celica coupe (and I'm not sure if that's a good thing or a bad thing). I think the 180SX is dreadfully bland. It's not bad looking. But it has no excitement to it at all. It's just a liftback coupe thing with no interest in its lines, and bad graphical elements (ie wide expanses of taillight plastic on the rear garnish). The S13 Silvia is a little better - getting closer to R32 shapes. But still....bland. S14? Nope. Don't love it. S15...a little better. Probably a lot better, actually. Benefits from not being like a shrunk in the wash R34 (where the S13 was a shrunk in the wash R32 and the S14 looked like a Pulsar or something else from the stable on Nissan mid 90s horrors). The Z32 was hot as f**k when it came out but hasn't aged as well as the A80. Keep in mind that I think the R33 is the most disgusting looking thing - and out of all the previous cars mentioned is objectively closest to my precious R32. It's just....real bad, almost everywhere you look. And that is down to the majority of what was designed in the 90s being shit. All Nissans from that era look like shit. Most other brands ditto. In that context, the FD absolutely stands out as being by far the best looking car, for reasons already discussed. Going behind the aesthetics, the suspension alone makes it better than almost any other car.  
    • If they just called it the "Mazda Tiffany", it would have been spot on.
×
×
  • Create New...