Stacker and RCA cabling to the boot

[Evil]

I have to feed both of these to the boot of my 33, any know the best way? the old stacker cable was feed under the ash tray through near the gear shift and then down under the passenger seat to who knows where then into the boot. is there any way of doing this without removing the seat as i would like the cables as neat and as out of site as i can?

[jlnewton]

I have my stacker cable and RCAs going under the centre console along the driveline tunnel, then under the back seat. I then ran it through the same hole as the wiring loom. Don't like running them so close to all the other power wires but it doesn't seem to pickup any noise. Must have good shielding. That was the shortest route I could find.

Don't think it would be possible without taking the back seat out.

[akeenan]

when it comes to laying cables

neat = remove rear seat, if you dont remove the rear seat it simply wont be neat and it will be dodgy

[hippy]

i line it to the side of the car and put it all under the side bottom panels ... don't need to move no seats ...

[KamikazeR33]

ive got mine the same way as hippy

works fine

easy as too

just take off the kick panel, sil panel, remove bottom seat from rear, take off side panel, thread cables through the side of the seat.... easy