Jump to content
SAU Community

Recommended Posts

im selling my R33 turbo, highflowed by GCG with tags on it.

i have owned this for approximately 8 months and have done 10,000kms on it.

i purchased the turbo off a good friend who got it built and only drove with it for a 1000kms before he smashed his car

i ran 10psi everyday never had a problem boost cames in early and was very resposive

reason for selling it, is because im selling my car and to make well spent money back i decided to sell items

seperately

im asking $1250ono

located in melbourne

Edited by apealn_r32
Link to comment
https://www.sau.com.au/forums/topic/177797-fs-gcg-highflow-r33-sold/
Share on other sites

how much power did it make at the rear and wat sort of supporting mods?? is it standard rb25 highflow or vg30 oversize etc?

thanks

im selling my R33 turbo, highflowed by GCG with tags on it.

i have owned this for approximately 8 months and have done 10,000kms on it.

i purchased the turbo off a good friend who got it built and only drove with it for a 1000kms before he smashed his car

i ran 10psi everyday never had a problem boost cames in early and was very resposive

reason for selling it, is because im selling my car and to make well spent money back i decided to sell items

seperately

im asking $1250ono

located in melbourne

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hard to say, just pop the rocker covers off and have a look if you think it's cammed. You probably need to replace the valve cover gasket/half moons anyways.
    • From my youth: GTi-R clutch change is a massive pain. The gearboxes are fragile? But the car is super cool and I want one 馃槩 
    • Remember this is 1988 tech.
    • Driveline vibration is resolved. I ended up loosening all my engine mount and trans mount bolts, giving it a good shake then retightening everything and it's gone... Let's just say I was surprised that fixed it.  I've been happily driving it around again but unfortunately put zero time into my direct port/constant pressure WMI setup. I'm on vacation next week, so I'll try and finalize it then.  On a different note, I spent all week fuel/ignition mapping 2x 216L V16 engines. Turbo's were burning glycol and we swapped them out for larger units. We also had planned emissions testing on site, so I figured I'd be there the same week to use their instrumentation and massage any emissions issues out if needed. This was a first for me. Fuel management is similar in certain ways to automotive (i.e air density as load variable) but very different in others. It's all PLC based and AFR's are controlled by air and not fuel. They use a control valve between the turbo and air manifold to control pressure which in turn controls AFR's. Due to this, target AFR tables supplied by the OEM are in pressures and not mass which really through me off. They use air pressure vs fuel pressure tables. I also relied on an O2 concentration sensor the emissions team had in the exhaust. Ignition timing was also all over the place and we were losing a fair bit of power. They're now happily sitting at 16-40BTDC depending on load. We were making about 1600kw at 900rpm at 90% load. Engines were running a lot smoother as well.    
    • heh, aint no R32 ever meeting modern targa cage rules unless the driver is veeeery short OP, good luck with the sale, since its already in the land of freedom I'm sure you will find a good buyer.
  • Create New...