Jump to content
SAU Community

Recommended Posts

hello,

My car developed a wee problem whilst competing in time attack.

Its stopped boosting as it should/was. Its an R32 GTR running twin GT2860-5's and Blitz SBC-iD III.

The boost controller seems to be defunkt now, and the car is boosting (very slowly) up to aprox 1bar towards redline. I've reset the controller and tried new settings - nothing. I've had a quick glance of the BC pipes - nothing :yes:

The car is running VTA DV's.

Also worth noting the car has developed a problem idleing coming off throttle. (like a GTSt with a VTA DV). This has been occuring for a while though.

It is also overfueling on and off boost. Popping and banging all the time

any suggestions?

Edited by Adam Kindness
Link to comment
https://www.sau.com.au/forums/topic/178617-boosting-problems-r32-gtr-gt2860-5s/
Share on other sites

that's the first time I've seen

VTA DV's.
to describe atmo venting bov..

anyway, as said above... something is leaking.

could be the bov.

could be that the wastegate flap is flapping and therefore takes ages to build boost.

easiest test is to remove the bov and block off the hole and hoses and go for a drive.

if issue is still there, then the wastegate flap option would be a little more difficult to test/check.

hello,

My car developed a wee problem whilst competing in time attack.

Its stopped boosting as it should/was. Its an R32 GTR running twin GT2860-5's and Blitz SBC-iD III.

The boost controller seems to be defunkt now, and the car is boosting (very slowly) up to aprox 1bar towards redline. I've reset the controller and tried new settings - nothing. I've had a quick glance of the BC pipes - nothing ;)

The car is running VTA DV's.

Also worth noting the car has developed a problem idleing coming off throttle. (like a GTSt with a VTA DV). This has been occuring for a while though.

It is also overfueling on and off boost. Popping and banging all the time

any suggestions?

Sounds like a air leak in one of the inlet pipes after the turbos to me. Worth checking that all your flexible pipes are on properly and the clips are done up tight.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • interestingly enough, i found out the answer is yes. doing a flush did fix my recurring A/T light. it might have been because of the trans filter: but that doesn't really make sense to me. the fluid/filter was super dirty. would that increase the pressure in the lines and trigger an A/T light? does the car even have a way of detecting that? i have no idea. i've done 200+ miles after the flush and no A/T light. if my A/B solenoids went bad, i would think the light would've come on. shifts and drives way better now though...at 2k rpm instead of 2500...no hesitation and downshifts when i want it to. 
    • I vote go red. Only because I hate keeping gloss black clean. Was no worries helping out either! Glad you've survived the rain outs of QLD
    • I would again like too thank Matt for his help in me sourcing the detachable hard top for the little red car, without Matt's assistance in inspecting it and locking it down, I can guarantee it would have sold before I could get up to see it,  and as that was the only available NC hardtop in Australia, I consider myself extremely lucky on multiple levels To say I'm more that happy would be an understatement And, it is 100% water tight, I drove through torrential rain coming back south, and by torrential, they type of rain that doing 40kph in a 110kph zone was a real thing, and even then, the standing water on the Hwy was deep enough to throw waves I'm also more than happy that the huge "BEASTS" that Matt calls dogs didn't eat me for lunch, I'm sure the sniffs and licks were more to "taste test" me, over being to friendly Now to work out what colour to get it painted, panel match, or gloss black........first world problems are real
    • Actually I might have figured out. Looks like there is a tab according to google images but it's hidden. Silly me.
×
×
  • Create New...