Jump to content
SAU Community

Wider Front And Rear On R33


Recommended Posts

  • Replies 66
  • Created
  • Last Reply

Top Posters In This Topic

Your car looks good with the wide guards, but you definitely need some bolt on spacers for the rear! The rear wheels are sitting waaaaay too far inside the gaurds. Buy a pair of 25 or 30 mm spacers for about $120 and it will look phat!

Link to comment
Share on other sites

people what would you think of the du-luck rear wing i think its the gtr one off a r33 i have seen pics it sits low and hangs out the back ?? i like but not sure if it will go with the rest of the car

The R33 GTR Do luck rear wing is not just a wing, its part of the grp boot lid so you need to buy the whole boot lid, then you have to bond or screw the quarter pieces on so they line up with the wing, the actual blade is just a GTR blade screwed to the wing uprights on the boot lid, and is not adjustable.

Not the easiest wing to fit but one of the best looking drag wings out there IMO, here's some pics of one I fitted to a mates car..

picture035ag6.jpg

picture038mg4.jpg

picture034tj3.jpg

picture040xm0.jpg

Not sure about the GTS wing but it looks like it fits to a OE boot lid, looks a lot easier to fit.

Edited by DriftyR33
Link to comment
Share on other sites

well where would i get one??

Well the only place I know of is Do Luck them selves, the one I fitted was brought second hand so you could keep an eye on ebay but there rare, Do Luck are very good at keeping people from copying there kits but I'm betting someone has.

The parts you need are "Rear Wing Stay w/ Trunk Lid" & "Trunk Side Panels"

http://www.do-luck-usa.com/products.html?auto=BCNR33

http://www.do-luck.co.uk/r33gtr.htm

Not cheap though, you could just go for the GTS rear spoiler that still looks very cool IMO

http://www.do-luck-usa.com/products.html?auto=ECR33

http://www.do-luck.co.uk/r33gts.htm

:rofl:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share




  • Similar Content

  • Latest Posts

    • Great info @tidi0x  Will definitely be handy for others and maybe me if I decide to keep the shit box H pattern.
    • Bumping this up one last time.... I wanted to follow up on the clutch slave issue. I realized that what the issue comes down to is the pocket is flat milled, and the cylinder does not want rest flat. So in order to mount it correctly you will need to make a spacer for the fingers so the cylinder is floating. I took two plates of aluminum, drilled some holes and was good. I did still need to make the relief cuts in the bell housing, as even with the spacer the bleed section still interferes. The OE bell housing the mounting holes are raised from the housing.       
    • If the event in USA goes ahead will be interesting as it seems the rules will get more cars over here. Apparently the track is laguna seca too. Yeah s15, if I get a the lower dash trims, centre console and change front cross member to standard LCA position will fit clubsprint. See how rules are as i would rather do complete widebody than a bolt on flare to run the 295 with proper clearance.
    • If the car is legal height I can't see it being an issue. Found a thread on reddit that might offer some insight.   I got a ticket from a copper in QLD for my S15 being too low. They had this wheel thing on a stick that they put under the car and it hit my exhaust. Anyhow went to an exhaust shop to get the exhaust tucked up/hung a little higher and I wound the coilovers up a smidge. Don't think I even had to go back to the police station unlike when I got defected for having a carbon bonnet when I brought the S15 from the ACT to QLD and had to replace it and then rock up at a police station and have a yougish female officer who knew nothing about cars confirm that I had changed bonnets. Should have just painted the carbon bonnet yellow to match the rest of the car lol
    • Id like to race in the US i think alot of those track would suit me   For the s15? Youd be stuck between club sprint and the new Open Am wouldnt you depending on how much interior you have left in
×
×
  • Create New...