Jump to content
SAU Community

Recommended Posts

the drift day was bloody awsome! i wouldnt of been able to do it though coz i dont know how my car handles as of yet hehe waiting to go skid pan with the club then i try my best :mad:

sam lives up to his nick as dr drift hehehe

Link to comment
https://www.sau.com.au/forums/topic/1798-how-to-drift/page/2/#findComment-52356
Share on other sites

nice one =) we have an industrial zone here too.. =)

has a nice 90degree corner at the end of some uber over steer and to battle for a high speed cornering..

has plenty of criss cross roads =) ECT(estimated cop time) of about 20mins =)

not to mention the joondalup, whelshpool, canning vale special stages =)

Link to comment
https://www.sau.com.au/forums/topic/1798-how-to-drift/page/2/#findComment-52374
Share on other sites

I used to have a ball on the CVSS.... used to work right there... those sand dunes were pretty cool every luch break in my VW taipan buggy too....

The best bit about our area... ECT unknown.... they didn't show even after a few hours.....

Link to comment
https://www.sau.com.au/forums/topic/1798-how-to-drift/page/2/#findComment-52394
Share on other sites

Guest |aunch

I am very much in agreeance with Birty on this one, as opposed to Badbiki's idea of slide recovery. Badbiki's sounds like fun, but...

If you car oversteers (back end slides out), steer in the direction of the slide (this is known as opposite lock), so that your whole car is going in the same direction. This is what stops the back of your car from overtaking the front! Also, like Birty says, back of a tad, and leave the tranny in the gear it is in. If you try and downchange, the engine braking could lock up the rears (note: to down change without locking, blip the throttle on the downshift), and bring the car into furthur oversteer... even if you don't lock em up, you are still very likely to change the attitude of the car in a bad way.

The caveat to this, is if you have set up your car in a specific way and you know what you are doing with it, or, of couse, if you are driving a front wheel drive vehicle. If you oversteer in a front wheel drive car, DO NOT GET STRAIGHT OF THE THROTTLE! Be warned, I had some fun on a wet roundabout with this one day :D ! The transfer of weight to the front wheels can be rather scary.

In case you are wondering, I learnt the joys of oversteer in my first car, an old Nissan/Datsun Bluebird. Living in the Hunter Valley (right near the Wollembi Rd, for all you motorbikers), with lots of dirt roads, and too much spare time :D

Link to comment
https://www.sau.com.au/forums/topic/1798-how-to-drift/page/2/#findComment-53965
Share on other sites

  • 5 weeks later...

Fellers, why make it sound so complicated -it's not, it's easy. I've been doing it for over 50 years, and as long as we're talking about oversteer,would you believe,all you need to know is what direction you want to go,and keep steering in that direction [as many times as necessary]. Keep some gentle throttle on and do your best to catch it early.

Those who can do it,analyse what I've said,and you will realise that I am right,and we can then stop confusing people with "steer in the direction of the skid" and "opposite lock" etc., and just tell people that they don't need to analyse what they are doing,wonder "which direction is the skid" etc.? [by which time they're probably wrapped around a tree],and instead,just be gentle on the throttle,and follow natural instincts and keep re pointing the car in the direction you want to go.

Understeer --- now,that's another story,and I wont go into that much more difficult task.It's sort of possible,some of the time to get it under control,and stay on the road - sort of. Best thing to do is neither buy or drive any bloody stupid front wheel drive,naturally understeering killing machine.

Link to comment
https://www.sau.com.au/forums/topic/1798-how-to-drift/page/2/#findComment-69031
Share on other sites

hmmm, people always tend to think drift is just getting the ass out on a corner... its so not! drift is holding it sideways from before the corner and holding it until after the corner.

i haven't tried yet in the 180sx. ;)

Link to comment
https://www.sau.com.au/forums/topic/1798-how-to-drift/page/2/#findComment-69305
Share on other sites

Come on -- drift is just a longer,more controlled version of getting the arse out on a corner, PLUS it's the slow way through the corner. Except only on some specific dirt corners -- NEVER faster on bitumen or concrete. Looks good,but it's S L O W..

Fast is brake late and hard,right line through on maximum throttle without breaking traction, and exiting on full power without getting off line. All smooth and tame looking,but I'd be half way to the next corner by time the spectacular drifter got out of the first one. See ya later!!!

Link to comment
https://www.sau.com.au/forums/topic/1798-how-to-drift/page/2/#findComment-69889
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...