Jump to content
SAU Community

Recommended Posts

  • Replies 90
  • Created
  • Last Reply

Top Posters In This Topic

the driver was hitting the limiter before he took off and creeped up forward... then the official sort of lost it and told him to move back... then he revved dumped like he just stole the gtr went left right left right until it looked like he touched the brakes and ended up smacking the rear end mostly on the other side.. maybe he shit himself and got nervous on the track :kiss: does insurance pay for LEGAL drag racing...

and btw CRAKED why werent u racing ur car!.. remember i was going to swap u the bonnet and boot at safs.. i own that white r33.... saw ur car in the car park looking lonley.. shouldve been on the track champ!

Insurance will not cover the damage even though he asked the question of the officials at WSID. :kiss:

The official didn't lose it at him at all, btw. He directed him to roll back through the beams as he had crossed them with his front wheels.

lol, from up top the official looked frustrated because people dont realise that they have a certain mark where they have to stop, thus why the chrismas trees have the 2 top lights that tell u to stop, they should have a sign that displays STOP WHEN THE 2 LIGHTS FLASH or something,

and i think it would be awesome if they had a big screen tv with replay action :kiss:

yeah big screen action reply would be a winner. considering each race only lasts 12 seconds or so and it takes a minute or two between runs some nice replays would be cool.

Hate to say it but this tool deserved what he got....

Before even entering the water area he was bouncing off the limiter for easily 10sec, then the official says oi u arent even in the water so he drives straight through the water and gives it another bounce off the limiter just incase he forget where the redline was.

Then he throws it in reverse to backup to the water but realises its 4wd so wouldnt do a burnout anyway so heads towards the line. Stops a full car length short and bounces on the limiter again ready for the green light. Starter official motions him forward and he rolls straight past the line, then reverses back and slowly rolls forward again whilst sitting on the limiter again.

The starter did his usual pissed off start by not waiting until both cars were set (gtr was still rolling) and soon as the 2nd pre-stage light is up he hits the button and the gtr driver decides to let the clutch out. Does a few left to rights and throws on too much opposite lock, front wheels bite and send him sideways towards the opponents wall (whom would have been shitting himself as much as the gtr driver) and takes out his rear end.

No not even 4wd will save dickheads.

:blink:

Edited by benm

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Thanks, plan is to drain all fluid tomorrow and do smoke test to find out the leak.   Appreciate your help and want to understand how the system work. So cooling is achieved by the long loop not any rad? The diagram seems to suggest it connects to somewhere inside the cabin and I thought that is a cooler inside firewall. If you look at the diagram it seems to show it connects to something inside firewall. I tried chasing it but not easy unless I take loads off   i am confident pump is good as fluid goes in and it gets soft( steering) but as soon as I turn engine off , loads of bubble come to surface and overflow. When engine is on , fluid level is below minimum but when off it shoots off and thinking it is sucking air in. I suspect aluminium pipe may have a crack line or whole   smoke test with no fluid should be a good start and if needed will remove the pump   In addition, the one going under the engine bay is high pressure line and one directly connecting from pump to resorvoir is return/ low pressure?   finally I searched and suggestion is to use dexron 2 but that is discontinued so bought dexron 3 as all research suggest it is compatible and shouldn’t cause any issues/ blow seals. I bought two liter of dexron 3 motul atf
    • Don't worry about. Just don't try to drive hard enough to make boost and you'll be fine.
    • Yes. This has already been said. It is a loop of hardline in front of the radiator. Because.... the pump is on the LHS and the steering rack hydraulic connections are where they always are on a RHD steering rack....on the RHS. The high pressure line goes down under the engine, along the crossmember, like it does on all Skylines. Don't just throw expensive braided hoses/other kits at it. Work out what is wrong and fix that.
    • Still got the afm on the intake, clamps are shut tight, only loose hose is the one that goes from the j pipe towards the IACV, since it's next to impossible to find a factory hose and the barbs are different sizes (I'm still using clamps on this hose to try and help it seal on the iacv side) I've ordered parts to make up the hotside of the intercooler pipes, I'll plumb it in and see what happens in a few days I suppose The turbo's internally gated, can I just unscrew the tension rod to let the gate open?
    • Did this ever go further ? Would love some updated info 
×
×
  • Create New...