Jump to content
SAU Community

Bad Design In Cars


donut_kng
 Share

Recommended Posts

  • Replies 104
  • Created
  • Last Reply

Top Posters In This Topic

actually it (aerial) had a power led lead on the stereo, which is what "I" hooked up, it was my nooby to jap wiring stereo install. I cant remember exactly it was aggges ago but in the manual it said for elec aerials use this wire, which is what I did. When my switch is selected as down the aerial comes up half way when stereo is on and if i switch it up it goes up to full height. No matter what it always goes up half way if the stereo is on. Im going to install the leds into my dash and a few other bits an pieces i,e, custom mock up panel for my temp guages in the din area so ill have a look and disconnect the wire and see if the aerial only works on the swtch. Pretty sure I tested this wayback when but it didnt move.. memory doesnt completely recall. Guess il find out again anyways.

Edited by gts-4 dreamer
Link to comment
Share on other sites

I've always thought boot space in R33s is pretty shocking for a car that size

i thought the boot space was decent considering there's plenty of leg room for the rear passengers, compared to 180's and supra which have shit all passenger leg room

Link to comment
Share on other sites

the cup holder in the VP commodore that is there but NOT useable.

its in the front centre arm rest box to put stuff in thingy and you have to cut out a hole and re position the leather to get to it... i think they used the same arm rests for the luxury models.

it was not even an option

Link to comment
Share on other sites

how about d/s window controls in the 32gtr, when the window's down any water on the roof pours into the switches? yeah!

hey nissanskyrice, go see supercheap. they have a headlight controller that turns your lights off with ignition,

plus has light sensor that works really well. should be standard in all cars tho...

Link to comment
Share on other sites

how about d/s window controls in the 32gtr, when the window's down any water on the roof pours into the switches? yeah!

hey nissanskyrice, go see supercheap. they have a headlight controller that turns your lights off with ignition,

plus has light sensor that works really well. should be standard in all cars tho...

Awesome. Going to stupid cheap thisarvo then. where does it hook up? under the dash or in the engine bay? i have to pull my dash apart again after installing my stereo on the weekend because i apparently unhooked the power to my turbo timer while i was at it :)

Link to comment
Share on other sites

lots and lotsa stuff

but, on Nissans, apart from the cursed filter location on GT-R's, the key release button. but you do get used to it after a while i guess

LOL I'm sure you can fix that some how? My ariel only goes up when I have the radio on, not the mp3 player :worship:

Link to comment
Share on other sites

beeping everytime i put it in reverse,leave a door open or leave the light on just for a sec so i can see the f**king keyhole to my front door.

seriously its the most anoying thing i have ever came across. beep beep beep its like owning a f**king truck.

i will settle down now.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share




  • Similar Content

  • Latest Posts

    • As far as I know, Infiniti stopped importing vehicles before 2020, even though they were still selling their stock for at least a year or 2 after that, they were older build years, therefore, you can import a 2020 400R, because you couldn't buy an AuDM 2020 built Q50 RS. As for insurance, you might need to go through one of the enthusiast insurance companies, they tend to insure a lot more grey import models than the mainstream insurers as Duncan mentioned.
    • loved seeing the zenvo on the a1 just after the hatfield tunnel i was the guy in the white van trying to egg you on it sounded awesome and those exhausts glowing red inside insane cheers for the thumbs up tim and tom.
    • So.... when I'm finally getting around to having my power steering leak sorted, now it looks like I've got the same issue most A/T Skylines are having. My A/T light will randomly come on and I'm stuck in 3rd gear until I turn the car off and on again. Only 3 weeks ago I did a complete transmission service: Oil flush + new gasket + new filter. This came out of nowhere!! It wasn't like the car was driven hard. I drove about 3 mins down the road to get fuel and boom!!!  Anyway, I have a few questions and hope you fine people can help me out here. All questions are in red. 1. The solenoids: I was looking at the parts catalogue in Amayama and I could only find the Solenoids as an assembly. https://www.amayama.com/en/part/nissan/319404ax05 I read in another thread that Solenoid A = 31940-4AX02 & Solenoid B = 31940-4AX05 but the Amayama product has only the code of B. Is this the right part? Can anyone who has done the Solenoid changes or seen them confirm if this is the complete set of A & B?   2. Gasket and Filter: I'm not going to try change the solenoids myself because it seems difficult to do in a home garage with just 2 jack stands. I plan to take it to a shop and get it changed. I was also going to buy the transmission sump gasket at the same time so I don't reuse the same gasket. Should I just use the existing gasket as it has only been on the car since OCT 19th? (~3 weeks) Should I be buying a brand-new gasket and a filter? Does this job involve taking the filter out?   Thanks in advance to everyone. It's hard to find a video of someone doing a solenoid change on a R34 so any help you can give answering my remaining questions would make me less stressed.
    • Yea - From what I have seen from the video, the car idles like any R34 lol 50PSI of fuel pressure is hardly super abnormal, the regulator is working because the pressure remains static when the throttle gets revved, i.e pressure remains the same when manifold vaccuum changes. Bigger pumps on stock rails always bumped the pressure in the rail without using an aftermarket regulator to change that. Do you know what your IAC is actually doing? Has there been any data showing the stepper motor % etc? There's no way your idle is actually moving around the way the cluster(s) are indicating. You would hear the difference with the engine RPM flying to 3k and 1k in mere seconds. I'd be checking the wiring to the tacho. What the tacho is telling you and what the engine/ecu is telling you are different things. I assume your ECU doesn't display the spike. So whatever is telling the tacho to be at X rpm is doing something weird. When the going gets insane, you're on the wrong path. You've ruled out plenty of things that are working correctly/aren't the issue. Your idle isn't doing what the tacho is indicating. You have two seperate issues, I don't think they are linked, and the idle seems reasonably okay unless it's stalling which.. well, it hasn't. Troubleshoot the stall if it occurs by figuring out what your IAC is doing vs what it is being told to do.
    • So awesome! I love the RB with the exhaust on display.
×
×
  • Create New...