Jump to content
SAU Community

Blowing White/grey Smoke -> 1 Plug Tip Is White?


Mr_GaZZa
 Share

Recommended Posts

Hey every1,

omg i cant believe it, i am blowing smoke... smells oilly!!!

more on tick over or crawling... and on standstill when u give it a REV...

its never done it b4

got my car boosted 'with manual controller' and dyno'd @ streetforce... i said i only wanted 10PSI

but the bugger tired for more when i got cash out!!! n said that didnt make much more power @ 14psi

i mean then he turned it down to 10ish!!

DAM!! what is gone? how can i look for wat it is? would i be valves guides? turbo? piston rings? :)

i am so angry now at him for that!!

HELP ME PLZ

GARY

Edited by Mr_GaZZa
Link to comment
Share on other sites

undo some of your cooler pipework and look for oil in the pipes

if you see a bit, wipe it away then run the car again

if it comes back quickly then youve probably shagged the turbo oil seal

or it could be leaking on the exhaust side, which is whats making it smoke, as you have raw oil leaking into the exhaust housing

Link to comment
Share on other sites

undo some of your cooler pipework and look for oil in the pipes

if you see a bit, wipe it away then run the car again

if it comes back quickly then youve probably shagged the turbo oil seal

or it could be leaking on the exhaust side, which is whats making it smoke, as you have raw oil leaking into the exhaust housing

:unsure: yeah i took one pipe of b4 it goes into the intercooler... looked coated in oilly stuff :P so gave it a clean.. going to install n start up again!

if its the rear , just remove the frontpipe n look?

Link to comment
Share on other sites

:unsure: yeah i took one pipe of b4 it goes into the intercooler... looked coated in oilly stuff :P so gave it a clean.. going to install n start up again!

if its the rear , just remove the frontpipe n look?

if your referring to the exhaust side youll need to drop the exhaust off at the dump pipe / front pipe area and look from there

its natural for some trace amounts of oil to be there (visual) but it shouldnt be dripping / fresh

Link to comment
Share on other sites

if your referring to the exhaust side youll need to drop the exhaust off at the dump pipe / front pipe area and look from there

its natural for some trace amounts of oil to be there (visual) but it shouldnt be dripping / fresh

:P

okay working on that bit now!!

um... what / where can i find my PCV ... heard other ppl mention that with this issue... maybe mine needed a replacement.. awhile bk i had idle problems n kinda fixed it self

with lil adjustments to the idle screw!!!

also only other problem i had was WRX sound randomly... but only in winter /dampness ... once a week at most... maybe they where signs =(

hasnt done that for 2months but

omg :unsure:

Link to comment
Share on other sites

sounds like broken pistons.

NO NO!!! aint lost no performance, no heat gains, no real oil usage or any WIERD noises

i thinks its the rear turbo seals

=(

any1 else got any ideas??

BTW cars nearrly done 160 ### km

GaZ

Link to comment
Share on other sites

hey all :laugh:

been working / finding out stuff all day about my car!!

only smokes when hot, and only after its sitting ther n u give it a rev u get a lil puff...

it doesnt smoke when or acceleration or de/ acceleration and doesnt smoke when cold!

performance is same, oil pressure remains to its normal pressures i see and engines temps are well under half way !!!

me thinks it REAR turbine oil seal =(

LF new turbo / or place in Perth to rebuild it....

Gaz

P.S thanks every1 for ur input

Edited by Mr_GaZZa
Link to comment
Share on other sites

sounds like pistons to me, i had this problem too, same colour smoke ect. still had good performance, but blowing heaps of smoke and using up my oil. took it to my tuner he tells me its pistons.. pulled the engine to bits and all 6 ringlands were f**ked :laugh:

sorry, probably not what u want to hear, but before you get the turbo rebuilt get a leak down/compression test done

Link to comment
Share on other sites

Yeah, there is a way too find out which one it is

while doing a compression test.

I'm not too sure how to do it!

But i think it's were you put oil on top of the cylinder

and then when you do the compression test,

if it goes higher its your stem seals or if it stays the same

it's your rings.

Not too sure though so if someone could correct that will be good.

Link to comment
Share on other sites

noooooooooooooooooooooooooo!!!!!!!!

:laugh: RAWR

i hope its just something cheap/ easy to fix

omg BS >< if it was pistons wuldnt u be burning oil.. n wuldnt it be worse @ cold start :S

and i dont get no smoke while cruising... n stuff all or if any when pulling away **looks in mirrors**

also took off oil cap, no signs of back pressuse or spitting, just a slit change in idle...

=(

thanks guys.... i'll keep my options open, until i go to a few yards n mates @ tuning shops / nissan n see wat they

say 2

thanks ;)

BTW compression test will be done this w/e coming

Edited by Mr_GaZZa
Link to comment
Share on other sites

thats right.. if u put in oil and do the compression test it should help verify wether its valve guides, stem seals etc

just becareful wat shops u go man same thing used to happen in my other car, not a nissan but under load/boost it used to puff a blue smoke.. and sometimes on vaccum once cruising car slowing itself down from 80,60 it used to blow alot of blue

went to tonnes of workshops they said needs a rebuild, some said rings r going, some said valve stem seals or valve guides..compression tests came up fine. opened it up myself it was only a manifold gasket cracked,

even when i used to rev it at neutral up to 3 grand for 10 seconds then backoff it started to blow the blue.

sometimes its not as bad as it sounds.. get compression test first, start ur way from the bottom and go up

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Update: Done: -Running on 6 cylinders, one injector was gummed up. I made an injector tapper, bit of Teflon on the end of a metal rod.  That fixed the injector. Need to replace one injector plug, the fastener is broken. -Coolant bleed -Fixed 4WD warning light, bleed 4wd system -Fixed electrical problems: alarm, brake lights, various broken plugs  -Got all the parts ready to connect head drain. Head drain is fitted with a blocker atm Todo: -Fuel pump dead, Been cleaning out the tank, had a lot of tobacco looking stuff, think its OEM foam. Got a Walbro 460 to put in. Probably going to add a relay to give the pump a solid 13volts. Replacing all the fuel hoses, in tank etc. -Front drive shafts still not back on. Waiting on parts. Would like to buy some new ones, but probably going to patch these up for now -Replacing gas struts on back door. Waiting to be returned -Headlights need a polish/repair -Going to touch up the paint a little. -Clean up the interior -Connect up heater plumbing -Cosmetic stuff, powder coat replace rusty parts, replace rusty bolts, wiper blades, silicon missing rubber -A million other things
    • Don't do this unless it never gets hot where you are.
    • Upgrade time. Been a long time coming, but I was able to get my GTR to a reputable builder in the States. List of upgrade parts below: RB30 (Sourced from Australia) PRP RB30 timing belt kit with all options Nitto pistons Nitto I beam rods Nitto oil pump King engine bearings New RB26 Head (Grabbed during Heritage run) Kelford 272 cams mild lift Supertech intake and exhaust valves over sized Nitto Head gasket Greddy Oil Pan Sump GKtech fan blade and adapter Koyo Radiator Borg Warner S362 SXE 6boost turbo manifold T4 divided  Turbosmart wastegate Pro-gate 50 lite ID1340x injectors Radium external surge tank Walbro 450 fuel pumps x2   All Parts in hand and awaiting my turn in line at the shop! 
    • For that price I might go buy one for just in case 
×
×
  • Create New...