Jump to content
SAU Community

Recommended Posts

hey guys,

i have been reading up a fair bit on how pinging/detonation works as a few nights ago....for the first time i took my car into the high rev range for one gear and noticed it was pinging... i nned to know...this is the first time i heard this but i have seen that by the time u hear it, it is to late... this engine has 60,000km on it and i put it in no longer than 1-2 months.. i have not gone past 3,000rpm since this happened... and have booked it in to be tuned and so forth...but..... is it all

Link to comment
https://www.sau.com.au/forums/topic/186923-is-it-all-over/
Share on other sites

No. Your engine can still be healthy. Constant pinging will kill your motor. pinging on the odd occasion/one off pinging like what you have done is not good, but it probably didn't do any serious damage either.

Get a compression test while its getting worked on/tuned, too see if the engine is still healthy just for peace of mind. Just don't let it ping again.

Edited by KeyMaker
Link to comment
https://www.sau.com.au/forums/topic/186923-is-it-all-over/#findComment-3375648
Share on other sites

just a quick question guys

what does pinging do to the engine?

hey dude... umm pinging goes hand in hand with detonation.... its when the compression in the cylinder is to great and is exploding b4 the spark and therefor settin things of as the piston isnt ready to take the blow.... ( im pretty sure).. pinging ruins your engine if u consistanly bang it... can go from busting up the rings to melting a piston ( im pretty sure again)

so guys.. from what i have told u... is the car stil drivable ( when i say that i mean i will granny it hard).. or should i just not drive it again until the tuner has a look??.

thanx for the quick replies guys.. apprecciated

engo

Link to comment
https://www.sau.com.au/forums/topic/186923-is-it-all-over/#findComment-3377339
Share on other sites

its best not 2 drive the vehicle unless need 2. if u need 2 drive it then baby it so it doesnt get 2 the stage where it starts pinging. also with pinging or detonation it is when the air and fuel ignite b4 the spark ignites and if bad enough can try 2 move the piston in the oposite direction and after a while weaken the conrod and worst cum 2 worst the conrod snap and end up through the block.

Link to comment
https://www.sau.com.au/forums/topic/186923-is-it-all-over/#findComment-3377610
Share on other sites

I've got a question sorta on the same topic here.....

Is pinging the same as KNOCK, measured by the powerfc?

I think i've heard my engine ping, but when i check my powerfc, the max knock was only 20. So would i be hearing ping, or something else?

Link to comment
https://www.sau.com.au/forums/topic/186923-is-it-all-over/#findComment-3377971
Share on other sites

pretty much theyre the same thing....... but the knock sensor WILL/CAN pick up other noises.. not only knocking.. iv heard many times the knock sensor picking up other rattling sounds coming from the engine... and it would give false alarms to the pfc..

also, it is very hard to hear an engine knocking...... unless if the levels are 80 or so..

its possible that youre hearing some other noises.. maybe misfire?

Link to comment
https://www.sau.com.au/forums/topic/186923-is-it-all-over/#findComment-3377991
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • f**kin' yikes! That insulation is the shittest stuff I have ever seen. You need to do an insurance job on that f**ker, pronto. WRT to the washer cover, I would have said that there'd have to be some at a wrecker, then remembered that it's a BMW, and reasoned that every single wrecked one would have been tailgating and so the front end would be trashed.
    • Oh and I lost my headlight washer jet cover!
    • Ok, so I got myself some X1 wheels really cheap to try out, they're a bit different and I like them but they're really narrow (18x8) they are available in staggered 18x8/9 also but really hard to find.  I kinda dig them, but not as much as the F10 19's I usually run, so these go into the wheel pile.         As I mentioned in another thread, I got a new exhaust. It's an off-the-shelf stainless one that fits OH-KAY. I don't love the tips size and how far they come out the back, I think I might cut the tips off and replace with some smaller (~3") ones that don't extend as far. It sounds really good though, I'm not sure if its just in my head but the car feels a little quicker, more responsive.      I fitted an eBay special front lip. Surprisingly it fit perfectly and all holes lined up. Its a little rickety but I haven't put any double sided tape on yet, I want to clean the front bar up where it has scraped the road a lot and fil in the number plate holes (or, get body coloured wrap to cover them - is this a thing?  I'm not sure if I'll leave it gloss or pain it matte. I really like it though, I don't particularly like the front bar without it, I don't really like the M-Sport and to get anything else is just too expensive. That said, I might need a new one now anyway as I dropped the car onto the jack after forgetting to put ramps under the front wheels. It bent a lot and while it did go back to normal after I got the car off the jack, I do fear I have not done it any favours.    Lastly, my headlights died. Different problems in each. They have gotten much dimmer over the past year or so, I put new (uber expensive) OSRAM bulbs in them but to no avail. One of them pointed at the ground and the other just kinda did its own thing with light working sometimes. Yeah, check this 18 year old BMW headlight wire. I reckon I know why they were stuffed.            BTW, the yellow and black is the power to the Xenons. Yikes. I hunted around an researched my options here. I would have loved to just get a replacement harness but not a thing. My car has adaptive headlights, that is they rotate left and right with the steering wheel. Good condition used adaptive xenons were over $700 each, non adaptive were around $400 each, but I couldn't help but think that they're all around 18 years old now, surely they'd have the same problems. So I looked at newer LCI headlights but they were even more expensive and I couldn't confirm that they'd be plug and play with lots of people having lots of opinions so not worth the risk.  I ended up getting brand new Chinese headlights from MARS. They're very close to OEM with only the angel eyes being a bit different. I didnt want crazy turn signals or sharp DRL's or anything. Not my bag.  They're not adaptive, I thought thats a feature I wouldn't really miss. So I coded that out.  The lights are awesome, they look so nice and they take so many years off the car. The angel eyes look great and the headlight brightness is ridiculous. I was so used to the old ones, I didn't realise just how bad they were. The new ones use the OEM bulbs, Xenon ballast and leveller motor which I was happier with. The only issue with them is that the rear cover is held on by SEVEN screws. This will be a nightmare to get to and open when I need to change bulbs.   
    • Now that you mention it I can see those too. More subtle. The lighting and low resolution makes it hard to assess super well what's going on but what is visible is bad enough to pull the motor.
    • I feel like this is due an update
×
×
  • Create New...