Jump to content
SAU Community

Fs: R33 T3/t4 T04e Turbo

nszs
 Share

Recommended Posts

nszs Collaborator

nszs

Posted
Posted (edited)

Hey guys, im selling my brand new, never being use before T3/T4 T04e Turbo with .5 bolt exhaust flange for $ 350 O.N.O OR i would swap it for a stock rb25det turbo that is good condition im selling it because i didnt expect it to cost so much to put the turbo on and i thought it would just replace the stock rb25det turbo. Call me on 0430324774 if interest any offer will be considered!!!

i need to sell it quick or swap it with stock one so any offer considered

Thanks Nam

post-37040-1191048744_thumb.jpgpost-37040-1191390801_thumb.jpg

post-37040-1191048668_thumb.jpg

post-37040-1191048585_thumb.jpg

post-37040-1191048507_thumb.jpg

post-37040-1191205027_thumb.jpg

Edited by nszs
Link to comment
https://www.sau.com.au/forums/topic/187236-fs-r33-t3t4-t04e-turbo/
Share on other sites
nszs Collaborator

nszs

Posted
  • Author
Posted
don't they have the whole set for $800? you might as well pay a bit more for the manifold and wastegate that they say will bolt on.

got a long story with my skyline, headgasket blow, turbo gone, gearbox screwed..... and im a newbie to skyline. already spending a fortune to rebuild the engine so im a budget and i didnt know it would produce this much power this t3/t4

thanks for reply

nszs Collaborator

nszs

Posted
  • Author
Posted
got a long story with my skyline, headgasket blow, turbo gone, gearbox screwed..... and im a newbie to skyline. already spending a fortune to rebuild the engine so im a budget and i didnt know it would produce this much power this t3/t4

thanks for reply

SOLD =]

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • sunsetR33
      ugently need expert / experienced opinion

      By sunsetR33 · Posted

      Just a follow-up on this topic. From what I can tell so far the rusty residue on the engine block might be unrelated to a coolant leak or maybe just older than anticipated. After driving it from the winter garage to my friend's garage I could not see any new traces of coolant leaking there, but I will test this properly once I was able to fully warm up the car and drive it for a bit. I think I can agree that the whole porous engine block stuff is kind of nonsense, but there is just a silly amount of true, false and half-true information on anything Skyline-related on the internet.
    • Butters
      UniClutch

      By Butters · Posted

      hrmmm , not mine , easter plans to pull engine not happening     
    • DRoc81
      R33 GTS25 NA - Stalling when vehicle is at operating temp

      By DRoc81 · Posted

      I removed the IACV, cleaned it and reinstalled.  I found a video on youtube that helped with the whole process, the guy then said the idle needed to be set, so the process was to get the vehicle up to operating temperature, unplug the TPS, set the idle screw in the IACV so the RPMs were around 600, then plug the TPS back in.  After I reinstalled the IACV, the car started (because, it was a cold start), once it warmed up, the car died, I adjusted the idle screw to see if that helped anything, it did not, I had to wait about 3-5 minutes, then the car would start back up. Only to shortly cut out, and only crank.  I loosened the TPS to see if adjusting that would do anything, and when I would rotate the sensor clockwise, there was a humming noise, but it would go away when I got the sensor in the horizontal position.  It only made the hum noise with the key on.  What do you guys think? 20250414_172604.mp4
    • Milkmun
      Magnetic Drain Plug Snapped in Half

      By Milkmun · Posted

      At least it was the ex.
    • Murray_Calavera
      Troubleshooting - motor wont turn over

      By Murray_Calavera · Posted

      Quick update.  The engine grounding strap was replaced, the engine is now happily running.  Tested the voltage drop before replacing the strap, was about 1.2ish volts down between engine to battery, chassis to battery. With the new grounding strap, pretty much no voltage drop at all. 
×
×
  • Create New...