Jump to content
SAU Community

Recommended Posts

Hello,

My '89 R32 Gts-T is for sale due to a recent addition to the family :)

It is a 5 speed manual, has a genuine 122k kms (I bought it at 78k kms, 2005) and it's had the timing belt and water pump replaced at 95k kms. It has rarely been driven in the last 12 months as it has not been my daily driver, and there is no room for a baby seat! It has been serviced every 5000kms and during the most recent service I replaced the plugs (NGK Platinum) and brake pads (Bendix Ultimate).

The car is in great mechanical condition but has a few aesthetic flaws with damage to the front bar and a couple of pin dents, one on the bonnet and one just in front of the sun-roof. It goes really hard for a near-stock skyline and handles beautifully with the simple suspension mods! It won't take much to get it going quicker. I have been told it has a high flowed turbo but I can't confirm so I left it out of the mod-list.

It has been my pride and joy up until 5 months ago when we had our beautiful daughter and I have been putting off selling it but its time someone else got to enjoy it and I get used to driving a family car!

It is currently registered until the 14th of October 07 and I will sell with or without rego and with or without plates (AAR32) depending on price. RWC will be arranged upon sale.

Mods;

Engine:

* Unknown Pod filter (looks like Blitz but unsure :rant: )

* Turbosmart boost-tee

* 3' Mandrel Bent Exhaust with 3' Canon (from the cat back and turbo gaskets replaced January '07)

Wheels, Diff & Suspension:

* Genuine 17" Rays Engineering, Nismo Rims (Near new Sonar 215x45 tyres front and 235x45 rear)

* Tein Coilovers

* Front strut brace

* Unknown brand 1.5 way Mech Diff (fitted shortly after I puchased in '05)

Body:

* GTR Bodykit (Front bar damaged on lower front passaner side, and in the middle and mesh has been removed)

* GTR Grill

* Genuine aluminium GTR Bonnet (Small pin dent front middle)

* GTS-T wing has been removed so holes covered with red race-tape

Interior:

* R32 GTR Buckets (Drivers side wearing through around the bottom)

* MOMO Race wheel (Starting to wear)

* Carbon RAZO Gear Knob

* HKS Boost Guage

Price drop, $10,500

Please contact me (James) if you're interested on 0410 344 475 or e-mail [email protected]

Car is located in Maryborough, QLD

post-42599-1191738953_thumb.jpg

post-42599-1191739094_thumb.jpg

post-42599-1191739221_thumb.jpg

post-42599-1191739372_thumb.jpg

post-42599-1191739479_thumb.jpg

post-42599-1192955795_thumb.jpg

Edited by AAR32
Link to comment
https://www.sau.com.au/forums/topic/188286-1989-manual-r32-gtst-for-sale-sold/
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

Hey guys, rego has now run out so i will sell cheaper as is for a quick sale, can also swap 17s for some stockish 15s (need new rubber though for rwc) for an even cheaper price!

Make some offers :ermm:

$10 500 price drop includes 17s, rwc and 6 months rego :)

Edited by AAR32
  • 2 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Is the 650rpm idle on the rb25det neo for stock cars only? I've never had my car before and after tuning it to idle at 650rpm when cold. Always idle's cold around 1100rpm, and then drops to about 900-950rpm. I've heard the r33 gtst's idle there. 
    • Series 1 RB25DET 5 speed gearbox, push type, 1st and 2nd gear syncros worn, may need bearings. Comes with quick shift, Tomei gear knob, release fork, bearing carrier, master and slave cylinder. $850. Cusco Super Single clutch,assembly, 225mm, used, comes with a Direct Clutch solid centre 5 puck ceramic clutch plate. $290. RB26 cams used, excellent condition. $280. HDI GT2 intercooler, excellent condition, has 3 inch piping welded to inlet and outlet. $250. All items located in South Eastern Melbourne. Please PM me if interested.
    • Hi all, I’m currently running a str pipe hi low hks exhaust and downpipe. Was wondering if I change out muffler to a titanium one will it change the sound of the exhaust? Plus I have always liked the look of the titanium pipes … anyone have recommendations to one?    side note already have titanium intake pipes. 
    • I looked up my other car that is a R33 GTST series 1.5. Anyone able to confirm what a Aero Form Bumper is?     (1G) 2 Door Coupe; (2GK + 11V) RB25DET; (4B) 2WD HICAS; (7F) 5 Speed Manual; (14G) Super Fine Hard Coat; (15U) Large Rear Spoiler + Aero Form Bumper + Rear Wiper (Aero Selection)
    • Ha ha, all good! I've almost caved in and realised I'm buying one.  I know myself well enough by now that I will start chasing ADHD butterflies half way through building it and not finish it so I'm better off spending the extra money buying one instead of making one just so I can get into straight away.  I would very much enjoy making one as fabrication is probably a strength and definitely a passion but I don't want that to be at the detriment to the car I'm ultimately building it for! There's some pretty good ones around for ~$1100 at the moment so I think I'll just go that way.  At the end I sell it or as mentioned, get another project to make further use of it! Thanks gents.  
×
×
  • Create New...