Jump to content
SAU Community

Recommended Posts

wasnt really planning on selling it till last week.

i want my own home, my OWN place to do what I want.

and that doesnt include the unit.

plus, i want a 34, but that wont be for a while yet.

i cant do those with a car-loan ( 2 g remaining) over my head.

and honestly, im over her.

doesnt excite me anymore.

you just need more power craig ;)

lol, and you wipe there chins :(:)

what and make Ryan cry all the hard work he has put in :down:

hardly mate, try again. lol

Edited by Ryanrb25

its easy to say adrian.....

but there is always something you will need the $ for when getting a property....

cost me and the missus a little over 15 k for the re-furb on the unit....

it wasnt necessary, but once you start, you might as well do the lot,

just like a car really lol.....

i wish money grew on trees.......legal trees that is

im there with ya ryan....

asking 13 and not going much lower than that!

id rather keep it than cut my balls off and undercut myself.

same goes for pretty much every car on this forum,

worth more in centimental value, than $ value

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I bought one for a 32 and it was junk, found its way into the bin
    • have a look at the other 2 stock rubber strips marked in blue. As you can see, they press against the cooling panel and leave marks. If the cooling unit panel isn’t there, the strip press against nothing therefore have no use. So Nissan was thinking ahead when they manufactured the cars, as they must’ve known people will install the panels in the future. Otherwise think about it, why else would they be there? Therefore that in itself directly infers that cooling panels do something. It might be to stop water and stop some air from going above the cooling panel so more of the air can be redirected between the cooling panel and the front bar towards the condenser and radiator. I tried to take a pic of it while the bonnet was closed but u can’t see shit in the photo
    • @DraftySquash @Duncan i misspoke, or this might be the other way. someone sent me a low res pic of it on It might completely close off the gap in red like in the second pic (second pic has gktech cooling panel on) .The 3 holes are for the plastic rivets used to secure down the front bar. The outer holes on the radiator side go underneath the condenser brackets If thats the case then there’s going to be no air going in through the grill between the bonnet and the bar for the radiator and condenser. Isn’t that bad? I mean less airflow to the radiator and condenser is all I’m saying
    • Interesting. Some of them were tight to lol
    • That's right, simple but works. Run out of load? Rescale the table lol. Want to be lazy and not rescale? Drag the K
×
×
  • Create New...