Jump to content
SAU Community

Recommended Posts

zzzzz

im off to Melbourne tomorrow :)

only reason i could justify i trip down is to get money off grandparents for my bday and xmas and then go buy myself an RB25DET -__-

cool you will notice a good power gain there mitch over the DE ;)

cool you will notice a good power gain there mitch over the DE ;)

yeah , cheers for the advice allan

now to raid someones credit card >_>

also , how hard would it be to put the engine in my self with a mate or two

and obviously get a tune up after its been put in

178 for wanlis is cheap? i cant remember how much i used to pay for them, thought it was less than that though. Kye, if you want new, go see graham at bob jane modbury, lauren should be able to sweet talk him lol, otherwise tell him i sent you down there or i can ring him and tell him your coming in and to help you out with what he can. Did the same for Eddy last week.

so you wont need to get it re-tuuned then, which is impossible any way....

sam, i go to fitness first holden hill, used to be a body builders gym, si its hot loads if equip.

you?

i was going to viva fitness at findon last year, but finished my membership and now i lift with my mate, hes got a bench setup and all that.

was thinkin of going to fitness first awhile back, i hear they have a pretty good facility

thanks luke :) ill be getting pretty messy at mawson lakes hotel sat night

any one feel free to come!

dan, ryan came round today, but we snapped a turbo stud, ;)

got captain thread comin out tomoz, then ryan is comin back to finish it off

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • is it common on RB25det motors that the exhaust manifold nuts become loose overtime? I was inspecting some stuff and noticed that a couple of nuts were so loose that I could literally turn it by hand. Everything is stock on exhaust side unless when they installed the dump pipe they had to remove the manifold for whatever reason. I'm surprised the boost leak didn't show up on the test lol.
    • Haha watch Alex's eye twitch when you mention Nistune to him in person lol. He's not a fan, then again it's quite a niche product. I personally don't mind them, but most usually steer clear from it. Word of advice, do not ground the AFM to the chassis, there are heaps of incorrect guides on the interwebs. Send both GND on the AFM back to Sensor GND on the harness.
    • Note I edited my post, so Sleeper's quote is not the same as what I meant any more.
    • That's a whole 'nother issue. Nissan ones get dirty and sticky. The coolant heats the wax pellet thingo to close the valve, so it is open when it is cold. And so if there is no coolant it just takes longer to close, because the heat has to soak all the through the inlet manifold.
    • I feel like this is crazy pills though. Isn't it locked up all the time anyway? It shouldn't flare anywhere if it only unlocks momentarily while it shifts gears. And if it flares like that when shifting gears, then the 8HP with a 5500 stall is not driving as well when on the road and/or track use..  
×
×
  • Create New...