Jump to content
SAU Community

B&m Supercooler 72066

WTFR32
 Share

Recommended Posts

WTFR32 Contributor

WTFR32

Posted
Posted (edited)

These where purchased but never used all items are brand new.

B&M SuperCooler 70266

I have four (4) and they are brand new (boxes missing). The core of the coolers measure 11"x8"x1.5".

they can be used for cooling engine, trasnmission, gearbox, diff oil etc. They use a 1/2NPT screw in fitting and are powder coated black.

These sell for $200 each. Price $50 Each

Goods are located in Sydney.

For more info please PM.

Pickup preffered

post-40697-1192259036_thumb.jpg

Edited by WTFR32
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • HYBRID VL
      Thinking of getting a Q50 300hp and just tuning it instead of getting the Q50 Red or 400R

      By HYBRID VL · Posted

      You could do that by all means. but yer it shouldnt be hard to get a VR30 to 400hp with an ECUtek on stock everything.  
    • Stivo
      R32 goes out in right curves

      By Stivo · Posted

      That's true. However, this problem has started since the tuning. First time with the return journey from the tuning. But yes, the pipe was clogged with dirt and rust. That was certainly due to age
    • Dose Pipe Sutututu
      CD009 RB Conversion

      By Dose Pipe Sutututu · Posted

      Great info @tidi0x  Will definitely be handy for others and maybe me if I decide to keep the shit box H pattern.
    • tidi0x
      CD009 RB Conversion

      By tidi0x · Posted

      Bumping this up one last time.... I wanted to follow up on the clutch slave issue. I realized that what the issue comes down to is the pocket is flat milled, and the cylinder does not want rest flat. So in order to mount it correctly you will need to make a spacer for the fingers so the cylinder is floating. I took two plates of aluminum, drilled some holes and was good. I did still need to make the relief cuts in the bell housing, as even with the spacer the bleed section still interferes. The OE bell housing the mounting holes are raised from the housing.       
    • robbo_rb180
      R32 Gtst - Track Car

      By robbo_rb180 · Posted

      If the event in USA goes ahead will be interesting as it seems the rules will get more cars over here. Apparently the track is laguna seca too. Yeah s15, if I get a the lower dash trims, centre console and change front cross member to standard LCA position will fit clubsprint. See how rules are as i would rather do complete widebody than a bolt on flare to run the 295 with proper clearance.
×
×
  • Create New...