Jump to content
SAU Community

Sold!

sloutch
 Share

Recommended Posts

sloutch Mentor

sloutch

Posted
  • Author
Posted
emanage comes everything including ignition signal adaptor too is it tuned? if so, what for?

E manage comes only with the basic adaptop. Yes there is a harness specific for certain vehicles. The last i saw it was about $150.

The injector and ignition harnesses are about $50 each if you buy locally.

This E manage was tuned to my R34 GTT manual at Chasers in Victoria by Paul who tunes rally cars around the world.

www.chasers.com.au

Link to comment
https://www.sau.com.au/forums/topic/189704-sold/#findComment-3418157
Share on other sites
sloutch Mentor

sloutch

Posted
  • Author
Posted
does the Greddy E-manage just plug and play ? :closedeyes: or need a auto technician to install it ? any software ?

No it's not just plug and play unfortunately.

It'll be good if you send it to be dyno tuned so that the air/fuel ratios can be adjusted accordingly. With the injector harness, it tunes the flow of the injectors. Had friends with 740CC nismo injectors running on e-manage.

No software. Your tuner should have one.

Link to comment
https://www.sau.com.au/forums/topic/189704-sold/#findComment-3420278
Share on other sites
DSR Apprentice

DSR

Posted
Posted (edited)

The emange works with er34gtt tiptronic?? Whats needed to make it work apart from pluging it inn? i can be emailed at [email protected] or www.driftsideracing.com

Whoops just read the replys :)

Edited by DSR
Link to comment
https://www.sau.com.au/forums/topic/189704-sold/#findComment-3423406
Share on other sites
sloutch Mentor

sloutch

Posted
  • Author
Posted
The emange works with er34gtt tiptronic?? Whats needed to make it work apart from pluging it inn? i can be emailed at [email protected] or www.driftsideracing.com

Whoops just read the replys ;)

Yes it does work on the R34 GTT Tiptronic.

A tune will be needed apart from plugging it in :). I have all the harnesses as mentioned in the post :)

Link to comment
https://www.sau.com.au/forums/topic/189704-sold/#findComment-3427783
Share on other sites
  • 2 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kyer32
      R32 gtst speedo out by 10kph

      By Kyer32 · Posted

      Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • Kyer32
      R32 gtst speedo out by 10kph

      By Kyer32 · Posted

      so I need a new speedo cable 
    • tsuokun
      R34 GTT RB rough idle problem with weird RPM gauge fluctuations

      By tsuokun · Posted

      Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • niZmO_Man
      R32 gtst speedo out by 10kph

      By niZmO_Man · Posted

      Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • niZmO_Man
      Rv37 400r questions

      By niZmO_Man · Posted

      +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...