Angle Wrench Necessary?

[Erelyes]

Howdy

The "bible" (workshop manual) for the 32R states that the conrod nut tightening should be done in two stages; 14-16Nm, and then, a further 60-65 on an angle wrench.

Is an angle wrench actually necessary, or is there a torque rating you can use instead?

Or can you just use a protracter and a good eye? Is that "do not use visual angle measurement" stuff just disclaimer rubbish?

I know a couple other bits in the motor use this angle wrench doohickey too.

Don't want to go hunting around for more tools if I don't have to.

Cheers,

Pete

[Adriano]

El cheapo ones are about $15, and will do the job, just a bit fiddly to use.

[The Mafia]

NEVER EVER skimp or guess when setting clearances, torque etc..