More Boost & More Lag.

[snappy_]

Hey guys,

Help me figure out this problem,

Ive just put a turbosmart single stage boost tee in my r32 and setted it on 13psi. Every time i boot it, it lags until 5-6000rpm before it gets moving. This also happened with my turbosmart dual stage.

I can't seem to find whats wrong with it!!

help me please im dying lol.. dying for more boost!

-tom

[R31Nismoid]

Probably a lazy actuator mate will be causing it, combined with the turbosmart boot-tee which IMO isnt helping

[snappy_]

Alright, that could be it?

Has anyone else had the same problem?

[Adriano]

Clutch?

[r33cruiser]

dont do it mate. i run mine on 10psi all the time. if i go ova that it is guttless, no more response. drives on a huge flat spot.

i have heard that because the ceramic wheel is soo light, it is ineffecient after 10psi. has little to no inertia compared to a steel wheel. ..just what i have heard

Edited October 22, 2007 by r33cruiser

[R34GTFOUR]

What happends when you disconnect the boost controller and put it back to stock?

a boost controller should decrease spool up time, not increase it. afterall all it does is hold the wategate closed for longer.

[R34GTFOUR]

i have heard that because the ceramic wheel is soo light, it is ineffecient after 10psi. has little to no inertia compared to a steel wheel. ..just what i have heard

that and the main fact that they break apart in a short period of time with any more than 14psi

[snappy_]

What happends when you disconnect the boost controller and put it back to stock?

a boost controller should decrease spool up time, not increase it. afterall all it does is hold the wategate closed for longer.

When i connect it back to stock, it just runs normally. with the fmic and exhaust, it runs a 11psi stock.

[R33Turbo]

Try gapping down the plugs, then boost up and see how flat spot goes...

[Simon-S14]

dont do it mate. i run mine on 10psi all the time. if i go ova that it is guttless, no more response. drives on a huge flat spot.

i have heard that because the ceramic wheel is soo light, it is ineffecient after 10psi. has little to no inertia compared to a steel wheel. ..just what i have heard

no disrespect but thats a load of crap

inertia has nothing to do with efficiency, just responce time of the turbo