Jump to content
SAU Community

Recommended Posts

I just used 2 female insulated terminals. They push on nice and tight and do the job just right. You can pick up some terminals at a repco or auto sparkys for a bout $3 or less.

Here's my install.

http://www.skylinesaustralia.com/forums/t1...87#entry3337787

You'll need a crimper. I also just cut the bottom of the bracket off so the pump fits easier. I stripped the wire back and soldered the wire before I crimped onto them too.

You need some more hose to reach the pump as well.

I used the extra hose and cut it up and used it as mounts to prevent excess noise. And just tightened up on them and the pump with 25mm-50mm hose clamps.

Edited by KeyMaker
out of curiosity, whats the walbro good for at 13.8 volts in terms of rwkw?

cats car had no issues making over 300rwkw with it. The car now runs a tomei pump but the only reason i swapped the walbro out was because it was nearly 2 years old... i have no doubt it would have continued on no dramas

cats car had no issues making over 300rwkw with it. The car now runs a tomei pump but the only reason i swapped the walbro out was because it was nearly 2 years old... i have no doubt it would have continued on no dramas

Is that the exact same one that SLIDE sell's, or a different version?

Apparently there is 2 different versions, ones a high flow (HF) pump someone mentioned?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...