Jump to content
SAU Community

Recommended Posts

10" wide is near impossible on the front unless you get much wider guards and beat the underskirt so there's no rubbing... maybe even tub it.

Kakimoto_front.jpg

we run 17x10.5's in the front and 13" in the back, but that's with a widebody, castor adjustment arms and rewelding new skirting to clear the tyres/wheels. that's so we get lots of traction on a track car.

10" wide 19's is kinda counter productive.... the profile would be so low you'd get no flex at all, would really affect the handling.

9inch on front with 215 stretched fit..

9.5 on the back with 225 stretched fit.. no need to lip the gaurds..

or just drive up a really high mountain and drive on some ice and get a similar effect.

235 on 9's and 255 on 9.5's are good, wouldnt go any lower than 225 on a 9"

im running 19s with 8.5/245 front and 9.5/275 rear no probs on stock suspension but im lowering soon and the workshop said id have to get the back lip most definetly

19by10inch all round seems quiet extreme.

even if i hit a nasty bump to fast up front i hear a bump/scrape.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Adjusting the idle screw is usually (emphasis on usually) just covering up deeper issues. Stuff like the cold start valve not closing properly. Throttle shaft seals on the way out. Coolant temp sensors getting out of spec. Coolant temp sensors especially can be a bear to diagnose because they can fail subtly. My dad just spent weeks chasing down his high idle. He cleaned the coolant temp sensor and everything but the resistance curve just drifts over time and if it's been 20+ years they also get super slow to respond as well. Has a massive effect on fuel economy as if it's off the ECU is going to run richer and command high idle for far longer than it should otherwise.
    • How old is the battery, it's more likely your battery is on its way out.
    • I reckon you'd get 90% off. My washer doesn't get between spokes very well. Haha! I love my Gerni!  Argh! Steam cleaning has its place for sure.
    • Hey all, I did a voltage test with the car (video attached) not running for 3 days. And here is some interesting stuff: - Battery voltage is 12v (I had the key in the ON position) - Drops to 9.76v while cranking then quickly goes up to 14.5v - You will notice there was a sorta slow start but not as slow as it usually is. - Idle surprisingly was better at just over 1,000rpm instead of 1,100 rpm. - I turned on the A/C, radio and headlights in the video and the voltage remains the same - I haven't cleaned the grounding wires on the chassis yet, that's next. - Battery drops to 12.6v when I turn off the car and wait a bit Seems like I might have a parasitic draw? I do have an immobiliser system which does drain the battery more of course but was wondering if there is anything else I should be looking at fixing? Does the ground wires on the chassis have anything to do with the low 12v?        SAU.avi
    • My lord that is some low oil pressure as minimum in the manual! I guess the big part will be seeing how it changes as the engine gets more spirited use.
×
×
  • Create New...