Jump to content
SAU Community

Recommended Posts

  • Replies 54
  • Created
  • Last Reply

Top Posters In This Topic

Kinda plain inside though. They do have that presence though with the kit and things.

People will pay a lot to get the 4 door for those that want easier access to the back seats. To find a good R34 4-door is pretty difficult, especially around that price

It is possible to find nice R33 4 doors cheap. I had access to 2 neat Grey 4 door autos with low km's. The were both around 11.5K. I nearly got one but decided I better buy a house before they go up in price so much that I can't afford one at all. My brother ended up with one with 50000 km's and immaculate condition besides one barely noticeable key scratch.

What do R34 4 doors go for? Similar to a chaser?

I was reading a HPI mag at work last night.

It looked like a JZE special as it only had supra's etc in it.

The 2JZGTE and 1JZGTE motors apparently on stock internals will shiet over a RB in reliability. Apparently in the US its not uncommon to pull 700od HP out of a stock JZE without problems.

The mentioned to look at www.supraforums.com I think it was.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • My muffler was fully customised to suit the car. He mailed me the end caps, I marked up the pipe locations (4 pipes in a single muffler) and he sent it back all welded. Certainly more expensive than a mass produced generic size, but that's hardly surprising. My R32 Exhaust has a Magnaflow muffler in it, if I need generic mufflers then they're usually a safe bet. I've got the Vibrant clamps on the intercooler pipes, just because they're nicer to use than the bolt together ones and not as expensive as a real Wiggins clamp.
    • Yeah. Nah. A grain of sand will take out a ceramic turbine that is doing 100000rpm.
    • Yes, it was checked with the roller rockers installed using a LS7 lifter that had been converted to a solid lifter with a dummy spring at 0 lash with a stock length pushrod. With the Johnson lifters longer pushrods were needed which are now 7.700" and 110 wall. Long thiccbois. People much more knowledgeable than I am are doing the measuring! 
    • Well... New things have arrived... And now I need to really dig into the design of the power steering reservoir.    
    • Interesting. I had that issue on my old car. After a rocker arm broke, the electrode must have been hit or something, though the cylinder didn't look like it was damaged when I put a scope down there, might have been the turbine but hard to imagine that a small piece of metal damage the turbine by that much. Seems like it's not even big enough to do the damage most of it.
×
×
  • Create New...