Jump to content
SAU Community

Spotted - QLD Skyline Owners


locutus_of_bris

Recommended Posts

Spotted loads of skylines on my way to brissy yesterday morning and a gt starlet flashing there lights at me.

a 32 on michigan drive

two 33's on the highway a black and a white one near bp coomera

00 r34 near springwood some old dude driving it

and a 32 with hakuna mattata written on the rear bar

Link to comment
Share on other sites

saw 6 skylines this morning in marochydore:

silver r33 with m.w performance on the side at about 10am

black r33 with 350z rims at about 10:30

white r34 at about 10:30

dark blue r32 at about 11

red r33 with black rims and a custom gts sticker on the back at about 11:30

silver r33 4 door at about 12

Link to comment
Share on other sites

Spotted JDM34 right outside my work today driving past. Which way do you take in? Because I never see you driving on the gateway.

I saw you first off at the lights turning into Metroplex and thought how close. I take the Gateway, I don't know how we don't manage to see eachother..

Link to comment
Share on other sites

lool thats v-power racing for u...mayb? lol

spotted a very sexy grey/silver33 in the springwood micky d's car park this evening, bout 7.30-8pm ish, i think the first number in the plates was a 2

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Installed  Nismo coppermix twin competition spec last year in my bnr32 with pull trans with Oem slave cylinder. The point at where the clutch disengages/enages is right at the top of the clutch pedal, meaning I barely have to push the pedal down for the clutch to be disengaged.  You guys that have the same combo are you experiencing this high pedal bite point??   Secondly I’d like to have the disengagement point lower meaning I have to push the pedal more(further not effort)for it to be disengaged.  I’m thinking to use a Nismo big operating cylinder(bigger bore at 13/16 vs Oem 3/4) which will require more pedal stroke to get the equivalent movement at the clutch fork. But I see Nismo web site says not to mix these 2 as the Nismo big operating cylinder doesn’t have enough stroke to disengage??? Any folks run both the coppermix twin pull with Nismo cylinder??    Thanks in advance for the replies but prefer only guys with pull clutches to respond. thanks     
    • Any chance u could let us know where your based ?
    • That’s a great deal and I would jump on it if you were closer. Melbourne is a bit of a hike for me though unfortunately 
    • I wonder if there is much to tell without knowing where the bolts where bought from. If it comes from Amazon or similar all bets are off. Can't trust them. And I fear not everybody knows that. Wasn't it @TurboTapin who ended up with the fake fuel lines recently? The submersible ones which very much weren't submersible at all. It kind of applies to everything nowadays. Doesn't matter if it's hardware or electronics. The fancy camera might have internals swapped out for cheap knockoffs. The hard drive will report a certain size but not actually be able to write it all. Shit like that. A bit depressing but the reality is you really have to be weary of where and how you buy stuff
×
×
  • Create New...