Jump to content
SAU Community

Recommended Posts

Hi,

I recently accidentally left my headlights on and drained the battery. Got a jump start took it home and recharged the battery.

After that is when my problems started happening.

The battery would go flat again every few days. Something was draining it. Anyway as a result when I started it the stereo died out.

Pulled the stereo out and with a multimeter found the constant power cable reading very low voltage(like 2-3volts). So no choice we just hooked it all up to the ignition power (which read 12v constant) and used that instead till later when I will rewire another power cable.

Now after that weird incident with the stereo, the climate control and clock settings always reset themselves after each time I start the car. So I reckon I've blown a fuse or something somewhere which stores these settings. Anyone got an idea? I've checked the fuses in the car and engine bay aswell, they all seem to be fine.

Any suggestions to what I might of blown?

cheers

Link to comment
https://www.sau.com.au/forums/topic/194761-flat-battery-weird-electrics/
Share on other sites

The constant 12V is to maintain the "memory" of the A/C, stereo, etc.

If you drained the battery, it will not last much longer. Get a new one. And put the wiring back the way it was.

tell you exactly whats happend, you battery had gone flat, you've recharged it, however its no longer hold a stable charge, so when you crank the car the voltage drops off to maybe 5-10volts which is enough to reset the electrics because the voltage is not bouncing back quick enough when the alternator kicks in.

Like light said, check your battery fluid levels this might lengthen the life of the battery a little bit longer, not sure about the 33 S1's, but the S2 have their battery in the boot so its sealed.

good luck!

tell you exactly whats happend, you battery had gone flat, you've recharged it, however its no longer hold a stable charge, so when you crank the car the voltage drops off to maybe 5-10volts which is enough to reset the electrics because the voltage is not bouncing back quick enough when the alternator kicks in.

Like light said, check your battery fluid levels this might lengthen the life of the battery a little bit longer, not sure about the 33 S1's, but the S2 have their battery in the boot so its sealed.

good luck!

its not sealed. there is a drainage hose for the gases and dribbles. You can still check the fluid levels.

well i still have the original battery i think ;)

i had the same prob. just spent 3 bucks and ive never had a flat battery since

yeh i've topped it up with distilled water

there wasn't much missing

and the battery hasn't gone flat since, well there is enough charge to crank the engine but still having the problem keeping the settings for climate and clock

either way I will buy a new battery i guess

sucks because I bought this battery in april

would of thought batteries can be reused if they go flat

its not sealed. there is a drainage hose for the gases and dribbles. You can still check the fluid levels.

well i still have the original battery i think :wave:

i had the same prob. just spent 3 bucks and ive never had a flat battery since

never looked hard enough i guess lol, big piece of MDF in the way holding a sub lol.

Batteries can be reused once flat but they will never be the same unfortunately, just the nature of the way cells work

yeh i've topped it up with distilled water

there wasn't much missing

and the battery hasn't gone flat since, well there is enough charge to crank the engine but still having the problem keeping the settings for climate and clock

either way I will buy a new battery i guess

sucks because I bought this battery in april

would of thought batteries can be reused if they go flat

if you have enough charge to crank then its not your battery.. your battery should be fine

there is an incorrect wire going to your climate and clock.

check your fuses as well i guess...

im assuming its similiar to a HU, a acc wire and a 12v+ .

if you connect both to the ACC it will work but once your turn off your car it resets everything.

if i were u id make sure i hooked up everything properly and check fuses.

if worse comes to worst take it to a auto sparkie, they will charge for about an hour but it will be fixed

figured it out guys!

it was actually a fuse.

this fuse controls all the electrics in the car and also supplies power to the constant 12v to the headunit

it is located in the fuse box under steering wheel left hand side 7th one from the bottom 10A fuse.

so all is good now, rewired everything and getting 12.4v out of the line.

With 12.4V it is safe to assume the battery is healthy and ok and shouldn't require a swap?

It still starts up no problems every time.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok interesting i guess ill wait till using a manual gauge before making assumptions.
    • Not in any way a logical conclusion. Also, looking at those logs, I struggle to see how that much oil pressure can go away that fast unless you are sucking air into the pickup. Meanwhile the ECU voltage is chucking a huge wobbly which seems to be tied to the throttle position. 100% throttle results in decreasing voltage. It's a mess.
    • So didn't get around to installing a manual oil pressure gauge and then decided to take the car for a cruisey drive to a cars and coffee and brought the laptop along with to get another log using more gears to see if its an oil pressure issue under acceleration or after. this log has 3 gears of WOT where as previous had 2 and the oil pressure dropped once on the brakes, and the same again happens here which is interesting as it shows it can hold oil pressure while under acceleration but once slowing or just the lower RPM after a pull pressure drops. I will be chucking a manual oil pressure gauge on to confirm but so far this makes me feel it is not an electrical issue. Something else i realised is the pressure sensor also is giving temperature information and the temp stays steady the whole time which makes me feel like the sensor itself is showing a true pressure reading.
    • LOL.... fk...   there goes 25K to make 200kW
    • For sure the later RB26 variants had a different setup (6 cam voltage sender?), but the RB25DE/DET share the same ECU pinout/PCB footprint, and at the ECU plug it ends up being 'throttle sensor in' & 'throttle sensor out' (to A/T TCU) ...you stick a multimeter on these pins and you'll find them directly connected (0 ohms) ; I had an pair of Nissan ECUs on the bench long ago, and I noticed this throttle sensor in/out link, actually linked to an op-amp ...which was unpopulated on the NA board, but present on the T board and I went 'ah-ha!' in some moment of clarity... ...it wouldn't surprise me if they changed strategy here though (in the software and actual monitoring of this signal), because they did with other stuff (A/T signals).. and 0.45v as a trigger point makes sense, as that's what the external TCU units expect at idle ; kudos, thanks for that insight...I suppose it boils down to whether or not Consult can display real time data of that signal's voltage... ...in any event, it presents the same target...ie; rotate TPS unit to achieve 0.45v to suit both ECU&TCU, and where do you goto from there? Just disconnect TPSwitch connector and/or that plus TPSensor connector....or do you go for the throat and disconnect IACV solenoid and see if it still stalls? (probably throws a recoverable fault code and goes for default idle strategy?)...
×
×
  • Create New...