Jump to content
SAU Community

Recommended Posts

Hi,

I recently accidentally left my headlights on and drained the battery. Got a jump start took it home and recharged the battery.

After that is when my problems started happening.

The battery would go flat again every few days. Something was draining it. Anyway as a result when I started it the stereo died out.

Pulled the stereo out and with a multimeter found the constant power cable reading very low voltage(like 2-3volts). So no choice we just hooked it all up to the ignition power (which read 12v constant) and used that instead till later when I will rewire another power cable.

Now after that weird incident with the stereo, the climate control and clock settings always reset themselves after each time I start the car. So I reckon I've blown a fuse or something somewhere which stores these settings. Anyone got an idea? I've checked the fuses in the car and engine bay aswell, they all seem to be fine.

Any suggestions to what I might of blown?

cheers

Link to comment
https://www.sau.com.au/forums/topic/194761-flat-battery-weird-electrics/
Share on other sites

The constant 12V is to maintain the "memory" of the A/C, stereo, etc.

If you drained the battery, it will not last much longer. Get a new one. And put the wiring back the way it was.

tell you exactly whats happend, you battery had gone flat, you've recharged it, however its no longer hold a stable charge, so when you crank the car the voltage drops off to maybe 5-10volts which is enough to reset the electrics because the voltage is not bouncing back quick enough when the alternator kicks in.

Like light said, check your battery fluid levels this might lengthen the life of the battery a little bit longer, not sure about the 33 S1's, but the S2 have their battery in the boot so its sealed.

good luck!

tell you exactly whats happend, you battery had gone flat, you've recharged it, however its no longer hold a stable charge, so when you crank the car the voltage drops off to maybe 5-10volts which is enough to reset the electrics because the voltage is not bouncing back quick enough when the alternator kicks in.

Like light said, check your battery fluid levels this might lengthen the life of the battery a little bit longer, not sure about the 33 S1's, but the S2 have their battery in the boot so its sealed.

good luck!

its not sealed. there is a drainage hose for the gases and dribbles. You can still check the fluid levels.

well i still have the original battery i think ;)

i had the same prob. just spent 3 bucks and ive never had a flat battery since

yeh i've topped it up with distilled water

there wasn't much missing

and the battery hasn't gone flat since, well there is enough charge to crank the engine but still having the problem keeping the settings for climate and clock

either way I will buy a new battery i guess

sucks because I bought this battery in april

would of thought batteries can be reused if they go flat

its not sealed. there is a drainage hose for the gases and dribbles. You can still check the fluid levels.

well i still have the original battery i think :wave:

i had the same prob. just spent 3 bucks and ive never had a flat battery since

never looked hard enough i guess lol, big piece of MDF in the way holding a sub lol.

Batteries can be reused once flat but they will never be the same unfortunately, just the nature of the way cells work

yeh i've topped it up with distilled water

there wasn't much missing

and the battery hasn't gone flat since, well there is enough charge to crank the engine but still having the problem keeping the settings for climate and clock

either way I will buy a new battery i guess

sucks because I bought this battery in april

would of thought batteries can be reused if they go flat

if you have enough charge to crank then its not your battery.. your battery should be fine

there is an incorrect wire going to your climate and clock.

check your fuses as well i guess...

im assuming its similiar to a HU, a acc wire and a 12v+ .

if you connect both to the ACC it will work but once your turn off your car it resets everything.

if i were u id make sure i hooked up everything properly and check fuses.

if worse comes to worst take it to a auto sparkie, they will charge for about an hour but it will be fixed

figured it out guys!

it was actually a fuse.

this fuse controls all the electrics in the car and also supplies power to the constant 12v to the headunit

it is located in the fuse box under steering wheel left hand side 7th one from the bottom 10A fuse.

so all is good now, rewired everything and getting 12.4v out of the line.

With 12.4V it is safe to assume the battery is healthy and ok and shouldn't require a swap?

It still starts up no problems every time.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • GTSBoy on your suggestion on another thread I had a look at those injectors and ended up getting them because of the quality.  Got the expensive ones.  
    • Hey guys been looking everywhere to try and find the correct gtr hood latch support part number but only found the first half and when I search with that number it sends me to an r34. The first part I found was 62515. If anyone could help me with the rest then I’d really appreciate it. Or if there’s some alternative hood latch support that would work even better cause I can’t find any for sale. (Searched on upgarage, partsouq,buyee,rhdjapan) 
    • If you've only done the upper control arms on the rear, AND you have changed their length (by more than about 1mm) to set the camber you want, then you will definitely need/want to install traction arms also. Adjusting the camber arms on their own WILL introduce bump steer and make the car unpleasant to drive. Most owners have no idea that their car could behave infinitely better than what they put up with. I'm not entirely sure what the Stageas need, but I am thinking that unless you have massive front spring rates and pretty soft rear springs, you have waaaay too much rear bar. Oversteer city, in my estimation. Combined with possible excessive bump steer from maladjusted arms, that could be a recipe for nastiness. ATR43SS2 is not a highflow. It is an outright replacement turbo. It's a little bit bigger than the largest highflow profile that Tao does. Probably a solid 300rwkW turbo where the bigger highflows will be about 30-40rwkW less. Nevertheless, we're only talking about ~300 rwkW, which is well within the abilities of the stock ECu to run with a Nistune on board. I would do so without hesitation - and I will be doing so when I get my finger out and actually get the injectors and AFM installed. But, if you would prefer to drop a whole lot more money on the ECU side, then I suspect you're looking at Haltech. The Haltech fanbois here will all spout on about all the available engine protection you can have, that you can't have with the Nistune option. And they're right. But it doesn't really come for free either. You will spend more money on extra sensors and the like, plus the work to install them. If the engine was built and therefore represented a big investment to protect, then I'd say definitely do it. If you view the current (and forever into the future) shortage of replacement engines as something to prompt similar protection, then also, do it. If you see a destroyed RB25 as an opportunity to put in a Mercedes or other V12 (like I kinda do)... then your perception of the risk/reward might differ. These are good injectors. You can also get a "better" set of the same with more flow matching, for more $$. 1000cc is where you will want to be. You will need an R35 AFM and adapter tube if you want to stay with Nistuned stock ECU. Otherwise, if going Haltech, you can ignore. As for intercooler. Just about anything will do. You're only talking about ~300rwkW. Just put a big core in there. Be aware that return flows do add significant pressure drop and will cost power and will make the turbo work harder to achieve the same goals. If you can manage a proper crossflow, do it. I'm keeping my very good return flow because I'm only expecting to be in the ~250rwkW range, and will live with whatever outcome I get.
    • I have a heap that i have collected if you want some authentic ones still. Pm me if your interested!
×
×
  • Create New...