Pod And Custom Airbox

[Hulk1010]

I really want to put my old airbox back on (getting tired of the pod filter noise), the only problem is the snorkel doesn't fit becuase of the intercooler piping, is there custom airboxes i can buy? or even something to enclose my pod into as my pod is behind my front bar at the moment and i'm just a bit scared of too much water getting sucked up.

thanks

[Lazy-Bastard]

I made the factory snorkel fit by cutting it to fit around the cooler piping and then plastic welding (with a soldering iron it actually worked pretty well) a sheet of plastic over the hole, then made a partition with an inlet for the snorkel. The partition seals pretty well against the chassis and the bonnet and I also have a cold air feed from the front bar to the factory IC piping hole.

Will take pics tomorrow when the camera batteries have charged.

[RBWPN.6]

I used a file and filed out my old cooler piping hole for my cold air induction then added some pvc piping shaped like an L, maybe u could cut a hole bottom of ur standard airbox let in cold air that way and piss the pod off prob get good performance out of it. My thoughts newaiz..

[cheez]

ive done the same only i used a high temp sealant over a gaffa tape base to solidify the job. ill be making a custom snorkel soon to replace the hacked up one.

[Lazy-Bastard]

maybe u could cut a hole bottom of ur standard airbox let in cold air that way

Only problem with that is there would be nothing filtering the air before it hits the AFM. The filter panel in the factory box sits above the AFM.

[Lazy-Bastard]

Pics...

There is also a foam/rubber strip attached to the bonnet which mates with the top of the partition and I actually get a bit of vacuum resistance when I open the bonnet.