Jump to content
SAU Community

Recommended Posts

  • Replies 122
  • Created
  • Last Reply

Top Posters In This Topic

ok still got complete passenger door,LHF Guard,Boot with ser1 spoiler,rear brakes,rad support,head,rear trims,passenger a pillar trim,both b pillar trims,upper and lower control arms,diff,Rear Tail Lights (the right one has a crack in the indicator bit),stock bov,set of 4 AVS 16in wheels with tyres,dash pad (non airbag),steering wheel (non airbag),centre console (bottom is cracked but lid is fine),auto cluster,floor mats (missing skyline badges),rear bumper (has slight crack..can fix for 50bux extra)..and a few other bits and pieces

  • 3 weeks later...

How much for the dash pad including all of the dash/consol plastics?

plus how much for the plastic part that is under the dash on the drivers side?(sits above the drivers knees, i think it might be called the steering stroud or something)

How much do you want for the passenger door? no damage right?

noticed someone wanted the passenger window, wont need this so can take that out and sell to them!!

cheaper if i get the LHF guard with it as well!! will pick up from melbourne no worries!!

Pm or email me on [email protected]

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I have one and it was at ~43.5PSI.
    • Put a pressure gauge on the fuel rail.
    • I've uploaded logs / the current map to Gdrive if anyone has any ideas. https://drive.google.com/drive/folders/1FPnr22Z-EilG7tYdHSi0Qb07P2jfFLKV?usp=sharing
    • I'm running a Haltech Platinum Pro with the stock map for the RB20DET + tweaks for my build. When I started it this morning, the IAT was at 32F/0C (Outside temp was ~42F) and the AFRs went off the scale for my AEM gauge. I let it run for ~30 seconds then turned it off. I then did a smoke test, by hooking into a vacuum line directly behind the throttle body, and confirmed there was no leaks ( i let the smoke tester run for ~5 minutes / confirmed it was generating smoke before hand ). I then started the car again, after fixing a power steering leak.... and it seemed to be happy for ~30 seconds (was at ~11/12), but then seemingly shot back up to ~18 again. I then let the car run for a few minutes, thinking this was just cold start related, but the AFRs never came back down. I didn't let the car fully warm up, so maybe this makes sense, but I'm not sure what to do? The AFRs, when I last ran it, were normal, but because of personal reasons I haven't been able to break in the car. It was rebuilt last year. Engine / Mod list: Supertec pistons Spool rods Kelford 270 cams and Springs Stock crank Deatschwerks 900cc injectors Walbro 255 (Wired directly to the battery relocated in the trunk) NKG Audi R8 Coil packs + Conversion Harnesses from Wiring Specialties Holset HY35 turbo Haltech Platinum Pro ECU Haltech boost controller (wired in for high boost RB25 Neo transmission + needed bits for the speedo to work  
×
×
  • Create New...