Jump to content
SAU Community

Recommended Posts

  • Replies 153
  • Created
  • Last Reply

Top Posters In This Topic

well i was flicking the switch at 4000 rpm, but today i was allowed to go on the dyno again, and this time i flicked the switch at 3500 rpm = 171.3 kW!!!!!!!!!!!!

wooot!!!!!!!!!

and i think u might actually find that it didnt actually have anything to do with the dyno, the bottle of gas being used on friday had been siotting around for bout a year, and then i freshed it up the new gas, therefore getting a much better reading as it was fresher :D

WARNING - MANIFOLD DANGER!!!!!!!

LOLOLOLOLOLOOLOLOLOOLOLOLOLOLOLOLOLOL

Boom, out comes the footwell :P :P

or from another classic movie Matrix:Reloaded "hmmm, upgrades...." ;)

Edited by 342Four
here is one of my dyno runs

beautiful car by the way have you got a 4 1/2 inch cannon on that??? i was thinking for my car getting a 3 inch all the way with hi flow cat and 4 1/2 inch cannon. what you think???

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • FWIW the depth of the groove in the rubber pad is not super essential, the blocks are rubber and squish a bit. If you are worried an angle grinder will make a deeper groove quick smart
    • I mean, if you were to move the jacking points away from the original location, that is, away from the wheels and closer to the centreline of the car, then it will be more likely to overbalance and tip off the supports. Same as we talked about before. I was talking about moving for-aft. If the sill is bent outward or inward, then the car would obviously look unstraight from the outside. Hopefully that hasn't happened either. Again, you can do comparative measurements from the chassis rails to see if there is much deflection.
    • Can you elaborate what you mean with your first sentence? I meant move as in the bulge kinda seemed like it got pulled "outward" meaning it got pulled down and to the side with the jacking rail itself, so the load bearing bulge now sits lower than usual and is not level with the sill on the other side of the jack point. Either that or the jacking rail just got pushed in a good bit.
    • As well as being risky WRT tipping off anyway. Yeah, I wouldn't expect it to move. Just measure from the rear one to the front one on the good side, then measure that same length on the wrecked side. You will find the notches in the pinchweld, and the jacking pad. Just spray a spot of marker paint or something there.
    • but any other area than the bulge you are talking about will just cave in then? The front driver side is pretty bent so I don't know if that will work the way it is now. I can still kinda make out where that bulge is/was but it looks like the position of it also changed due to all the mistreatment? Hard to tell
×
×
  • Create New...