Jump to content
SAU Community

Q On Putting In Suspension Components

chopobo
 Share

Recommended Posts

chopobo Veteran

chopobo

Posted
Posted

My right steering rack end is bent. (the metal rods at the end)

I've acquired another steering rack and was wondering if it is possible to just replace the steering rack end instead of replacing the whole thing.

is this process hard?

I also have a lower control arm which needs replacing, I have the replacement part aswell and also wondering if it is easy to put in or is something that I should let the suspension shop do.

Thanks in advance

BHDave Grand Master

BHDave

Posted
Posted

The rack end is able to be swapped and it is a much easier job than replacing the entire rack :)

Removal of the LCA isn't that hard either. Getting the ball joint out of the hub can be difficult if you need to keep it. If you don't, then just buy one of the cheap ball joint remover tools from repco or supercheap and bash it out.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      NC MX5

      By GTSBoy · Posted

      Nope, but they are definitely one of the default choices. Well established.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Has anyone used > https://performancecoating.com.au/  
    • Ozdavroz
      R32 owner from ACT

      By Ozdavroz · Posted

      Haha actually I did join back then under a different email address,  I couldn't re-activate my account so made a new one! I didn't post much anyway so not missing out on much. Amazing to see how the value of the cars and parts has changed over the years, also ACT section appears to be dead now. 
    • Ozdavroz
      R32 owner from ACT

      By Ozdavroz · Posted

      Thanks... It's in pretty good condition overall, probably due to not being drifted/tuned however being a daily driver has taken its toll. Had 100k on the clock when I got it, up to 180k now. Unfortunately it's not 100% dent free, it's got a small dent on FLH side and broken indicator from where I hit a small kangaroo at high speed. If you look at closely at pic #5 you might spot the dodgy trailer light repair my old man and I rigged up as temporary repair! - It's still there due to a combo of needing the car as daily driver and then too lazy/busy to fix properly. I've a couple of other minor accidents accidents as well but nothing major. One required a new front bar and unfortunately the smash repairer ordered the normal gtst one and not the aero bar. Needed the car back asap so just went with it, regretted ever since.
    • GTSBoy
      How "plug and play" is the Haltech Pro for R33 GTST

      By GTSBoy · Posted

      I can't believe that anyone is foolish enough to believe that the base maps are for any other purpose than to drive the car up onto the trailer/truck or gently creep it to the dyno. No matter how good they are, they can never be any better than the factory maps**, and only the foolish trust those on a significantly modified setup. **Yeah, yeah. I know there's also the difference between factory maps being fixed to certain injector sizes and MAP/AFM/VE relationships, and the likely aftermarket ECU base maps being better able to handle the sorts of changes that would render a stock ECU dangerous, like different sized injectors. But let's just ignore that for the moment, because the principle is still the same.  
×
×
  • Create New...