Jump to content
SAU Community

Recommended Posts

I've only had the car a few weeks but something i have noticed is that if i keep the revs low and use even close to full throttle and change up gears without reving high i hear a popping sound from the exhaust which im assuming is a flame out as the tip is black afterwards. My question is, is this normal for a mostly stock GT-T? I just have a cat-back exhaust/pod filter/plumb back bov. Im assuming that r34's are tuned rich from the factory and this is simply a tune issue of too much fuel in and not enough burnt in the combustion chamber?

Has anyone else noticed the same sort of thing? Im sure its no big deal but just thought i'd ask.

Yup thats right.. Car is probably running a bit rich!!

That poping noise is normal for our imports.

Unless it full backfires and is fully hecticly loud popping noise then you gotta start worrying..

Yeah i sorta figured it was running rich, im used to cars throwing flames out the exhaust being the owner of a modified rx7 :P

The skyline is only a fairly quiet pop so nothing major. I guess its time to start planning some mods to be ready for a computer and a tune...

just throwing a tagger on here mate.

i can adjust my fuel pressure so i can adjust the backfire.

atm i just have a slight pop/barble on deceleration.

but when really rich it BANGS!!

how bad is it seriously.

I've only had the car a few weeks but something i have noticed is that if i keep the revs low and use even close to full throttle and change up gears without reving high i hear a popping sound from the exhaust which im assuming is a flame out as the tip is black afterwards. My question is, is this normal for a mostly stock GT-T? I just have a cat-back exhaust/pod filter/plumb back bov. Im assuming that r34's are tuned rich from the factory and this is simply a tune issue of too much fuel in and not enough burnt in the combustion chamber?

Has anyone else noticed the same sort of thing? Im sure its no big deal but just thought i'd ask.

Yeah it could be running rich. You could also try resetting the ECU, see if that changes anything (disconnect battery, press brake to drain remaining electricity in system, reconnect battery).

It's nothing too serious if it's only the occasional pop. When you start getting major hesitation and backfiring around the 4000-5000rpm mark you need to start replacing stuff, usually the fault comes down to spark plugs need replacing or re-gapping, coil packs, o2 sensor, fuel filter, fuel pump.. the list goes on - common problem with lots of common causes. Your occasional pop could be early warning signs of the above. Only time will tell.

Its not loud or bad, its barely noticable really, im just used to listening for stuff like this. It doesnt do it on deceleration either, well at least i havent noticed it do it. Only when shifting up with low revs after having some load. And its not a loud bang, just a light pop. And there's no hesitation at all, it pulls quite smoothly.

The motor seems in pretty good condition too, just had all the belts replaced from 100k service, and new sparks plugs (mayb i need to gap them correctly?), oil, etc.

Edited by Scottydoo

Sounds similar to an extremely common problem. It's doing it as you first accelerate, you go through a zone where it's stuttering or popping and not building boost well then it's back to normal until you slow down again?

Running slightly higher than stock boost?

It probably is running a bit rich, would also explain the blackened tip, but it shouldn't - depending where you intend to take the car I'd be thinking about a A/F addon or better yet an ECU that can manage A/F ratios and get sorted out properly on a dyno.

Sounds similar to an extremely common problem. It's doing it as you first accelerate, you go through a zone where it's stuttering or popping and not building boost well then it's back to normal until you slow down again?

Running slightly higher than stock boost?

It probably is running a bit rich, would also explain the blackened tip, but it shouldn't - depending where you intend to take the car I'd be thinking about a A/F addon or better yet an ECU that can manage A/F ratios and get sorted out properly on a dyno.

my car pops when i just let the accelerator go when im goin down a hill should i be worried ill replace my plugs just incase

No, every single car will do it.

It's just slightly unburnt fuel in the chamber exiting and igniting in the exhaust.

will a different gap on plugs reduce it? mine does it a fair bit and currently has 1.1mm gap ngk iridums (i believe thats the gap straight out of the box anyway)

ill probably get it adjusted to .8mm when i take my car in for some diagnostic dyno to solve my power cutting issue :)

Mines not popping on decel, only acceleration. I dont think its anything, just a bit rich i reckon. If it gets worse i'll start worrying but till then it can wait until i get a computer and a proper tune. Might gap my plugs for the hell of it in the meantime even tho it probably wont stop it.

Thanks for everyone's input btw

My R34 GT-T "pops" backfires mainly when cold if i accelerate hard then it happens as i decel. So i try to ease her in until she's warm. Doesn't happen when warm.

  • 2 months later...

Mine has been doing it when both cold and warm. The car is running stock boost btw.

I put in some Nulon Performance Engine Treatment E20 in the car yesterday and since I did i havent been able to get it to pop at all even when trying to force one out. Seems to have done the trick, and the car is idling smoother now too :teehee: Not bad for $13. So yeah, so far so good hopefully it stays that way. Maybe worth a try for you other guys?

*EDIT* Still does it sometimes, but nowhere near as much. Leaves less black on the tip of the exhaust than before though.

Edited by Scottydoo

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I’d love to find some where that can recover the dashes to look brand new and original. Mine has a very slight bubble, nothing compared to some I’ve seen though 
    • $170K. I asked one of the guys there as a joke if that price was just for the passenger seat as it was where the price sheet was... he tried really hard to crack a smile 😄 He also mentioned that every single part of the car was inspected and either restored or replaced with a new or as new part, or made from scratch. The interior was incredible, every inch like a new car.
    • Time for a modernisation, throw out the AFM, stock O2s, ECU into the e-waste bin. Rip out the cable throttle, IACV, pedal, etc. into the scrap metal bin. DBW, e-throttle, modern ECU, CANbus wideband, and the thing will drive better than when it left the factory.
    • I agree, don't go trusting those trims. As I said, first step is to put the logger away, and do the basics in diagnosis.   I spend plenty of time with data loggers. I also spend plenty of time teaching "technicians" why they need to stop using their data loggers, and learn real diagnostics.   The amount of data logs I play with would probably blow most people away. I don't just use it to diagnose. I log raw CAN data too, as a nice chunk of my job is reverse engineering what automotive manufacturers are doing.
    • I'm aware, but unless you're actually seeing the voltage the ECU is seeing and you're able to verify the sensors are actually working I find it hard to just trust STFT/LTFT. I will say, logging the ECU comes naturally to me because it's one of the lowest effort methods of diagnosis and I do similar things in my day job all the time. Staring at 20+ charts looking for something that isn't quite right isn't for everyone. NDS1 allows you to log almost everything so that's normally what I do and then sort out the data later. 
×
×
  • Create New...