Hks EVC 3. help needed...

[osc@r]

Hi.

any hks evc 3 guru's out there that can help me out with a little advice...???

In the three run set up phase, the controller accepts the boost and moves to the next point, too early in the rev range for all three steps, so that after the third run the controller has only seen a max boost pressure of about 0.5 bar.

Naturally when i then set the boost up to about .9 bar, the controller can't "controll" the boost and it will creep up to about 1.1 bar at redline. Does this make sense...?

Anyway... if someone knows how to programm these can they just gimme a few quick pointers. I might be doing something simple wrong.

thanks.

[osc@r]

bump...

[Steve]

Dont know anything about EVC III, but here is a link to a pdf manual if that helps?

http://www.alltrac.net/manuals/