Announcements
-
Similar Content
-
Latest Posts
-
Ok I’ll look into that I think - I was considering buying a scan tool also like nisscan and I’ll see what’s up with the O2 sensor someone else in person suggested I should replace it or at least give it a proper cleaning. Luckily theres a local skyline group so should be able to get in contact with someone and see if they can lend a hand
-
By Dose Pipe Sutututu · Posted
So you're saying the original bracket can't be used anymore with the new stalks? I reckon I have the same issue, considering I have R35 coils too, I need to gap the plugs under 0.5mm to stop blow out at 1.8bar of boost. -
By Murray_Calavera · Posted
Update time, the Efi Hardware bulkhead terminals are in. The quality of the kit is leaps and bounds better compared to the Efi Solutions/Taarks kit. I was not happy with the Taarks kit, however I am very happy with the Efi Hardware kit so far. Being able to torque down the plastic insulator is a huge help. The longer post and jam nuts also make life easier. I didn't bend the eyelet terminals 90 degrees to fit inside the bulkhead this time. I performed some surgery to the bulkhead to fit the terminals without bending them (in case the bend increased resistance in the terminal). Unfortunately I didn't have time to drive the car, but letting it idle for about 10 minutes and the power terminal went from about 13 degrees to 16 degrees. I'll update again after I've taken the car for a good shakedown to check temps. As promised, I have taken some photos so my crimps can be judged by all. Crimps were made with Delphi crimper (part number 12085271) Heat shrink is Raychem RW-200-E recovered at 170 degrees.
-
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now