Jump to content
SAU Community

Recommended Posts

Bought some BN WPI natural and vanilla.

The natural flavour tastes like powdered skim milk but ok if you make smoothies with it. The vanilla has a very faint taste too it. Definitely would choose ON in the flavour department for an extra $20.

I can see where you're coming from - the vanilla isn't really a strong flavour. I like it because it's simple and has the highest protein percentage, but I do agree the chocolate is much better! Banana isn't bad either, if you like the fake banana flavour haha

I'll grab BN chocolate next. I prefer paying cheaper and taste isn't a big thing for me anyway as i only have it once a day. Was just giving my thoughts for others who may not have had those flavours.

If I am doing a bike ride in the same day I am doing a PPP session I add a schoop of chocolate icecream to my shake, because I am a disgusting animal.

I use BN vanilla.

Edited by Nee-san

Dan I WAS paying $50 for 2lb of ON Gold Standard, til I started having 2 shakes a day.

If I were to get sucked into the bro marketing of the local supplement shop, I'd be paying ~$80 a kilo for Max's or Dymatize stuff!

Yeah the BN is $100 for 5kg of WPC.

I bought some fitbodies protein off ebay, $85 for 4kg. Serve size 30grms - 27grms protein, 1.2grms carbs and 0.8grms fats per serve. Chocolate tastes very good, better than BN. Mixes well with no clumps but does froth up a bit.

Little dubious on the protein claims and I'm sure the scoop is slightly bigger than 30grms but if taken at face value it's a very good protein at a terrific price.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Ohh even easier.   Go dial up 700rpm on the hand controller. Rip off the TPS plug, wait till the idle drops and then adjust the IACV screw so it's just a tad below the target on the hand controller (say 650rpm), plug the TPS back in and idle will climb back to target. Done.
    • Hey Sleepergm, I love your inlet piping, do u mind sharing who did the work, please? cheers, Ian
    • Yeah, you want the IACV to be running at around 30 "units", variously called "steps" or "duty cycle" depending on the person. That gives it room to go lower if need be and higher ditto.
    • Ah right that makes sense.
    • The RPM is just a target, the ECU will adjust things to try and hit that target but it's by no means guaranteed. If the IACV duty cycle is 0 or something like that and it's actually closing up fully then the idle is as low as it can physically go without reducing ignition timing. The problem can be something like the cold start valve in the IACV not closing fully, worn throttle shaft seals, torn rubber diaphragm in the brake booster allowing unmetered air, etc. 
×
×
  • Create New...