Jump to content
SAU Community

Turbo Squealing


Recommended Posts

Hi all,

Well my '94 GTR has started making a squealing noise on boost. Autotech say it could be a dying turbo (they were servicing it at the time).

The guy I bought it from had recently had the turbos 'overhauled' (I have the receipt) with steel wheels. But then the guy at Autotech says they're HKS units (which would make sense - the car has HKS piping and actuators). Some others on this forum have noted that HKS turbos squeal but I have no idea if this is true or not. The car also has a Greddy oil management system. It sucks because I'm pretty good at looking after it.

Any advice on what to do? ;)

Sig.

Link to comment
Share on other sites

My stock turbo started making a squealing noise on boost and when I took it off to replace it there were small chunks missing from the compressor fan fins.

Im pretty sure that if youre getting a loud squeal it does mean that the turbo is on its way out... Not sure about HKS ones though.

Link to comment
Share on other sites

Leaking exhaust manifold.

its either the manifold its self or where the turbo bolts onto the manifold..

Check to see if all Manifold studs are there, esspecially on the rear.

And look to see if there is any carbon around the manifold..

had Same prob, common thing sposably..

Link to comment
Share on other sites

turbos don't squeal unless they're really happy and they're girl turbos.

seriously; have a look at the turbos with a torch, it will either say Garrett or HKS on the inlet side but neither should squeal. who did the overhaul?

does it come and go with revs in neutral, revs with little / no boost or revs with load / boost. exhaust leak should make a ticking noise.

if it's easy to make it happen listen under the bonnet so you can try and pinpont the location of the noise. hopefully they can be more precise than 'could be a dying turbo' as you're unlikely to want to take the the turbos off on that basis.

cheers

Link to comment
Share on other sites

thanks heaps for all the great suggestions guys - it sounds more like a whistle than a zing. Like when people watch fireworks. Oooooh! Pitch gets higher as you accelerate. I think it only really starts at about 2100 rpm.

i do hear a ticking sound at idle, with the bonnet up.

i'll have another look at it in daylight tomorrow.

Link to comment
Share on other sites

If they're newish HKS's or overhauled, then I doubt the comp wheels rubbing on the front cover.

Considering they were recently taken off the car, i would say that its an exhaust leak, did you (or they) use the old gaskets?? Ill put 100 internet dollars on it.

Link to comment
Share on other sites

If they're newish HKS's or overhauled, then I doubt the comp wheels rubbing on the front cover.

Considering they were recently taken off the car, i would say that its an exhaust leak, did you (or they) use the old gaskets?? Ill put 100 internet dollars on it.

100 internet dollars lol nice :D

please do tell us what the problem ends up being i have a problem car so when it happens to me id like to know what it is.

Link to comment
Share on other sites

hi guys,

ok, i think i can see one of the turbos (one side, at least) at it says "Garrett" on it. Can't see anything saying HKS, but the guy at Autotech was pretty convinced, though?

The workshop was Precision Turbochargers. 2x Turbo's overhaul, 2x steel wheels fitted, $1600.

The 'ticking' i can hear in the engine bay is actually more of a tapping, on the left side of the head, rather than the turbo side. The tapping seems to stop momentarily when i rev it.

christ i wish i knew what i was doing.

Link to comment
Share on other sites

RB26s have noisy top ends, the inj and solid lifters see to that.

HKS turbos have HKS in raised lettering on the intake ie silver housing on the side facing the front of the car. if they were HKS turbos and were 'steel wheeled' that's unusual as they have steel wheels anyway, unless they were damaged. if the housing says garret it sounds like maybe they've just done a steel wheel coversion on the stockers.

did autotech suggest anything other than a turbo? i'd hope they could be more specific, or are they just as confused? try taking it to Trojan, John is a cluey guy.

don't worry too much, engines have all sorts of weird ass ways to make noises. have a look at your accessories, the ps pump can make bad noises when low on oil, and the a/c comp sounds like a meat grinder if it needs gas or it's bearings are shot.

also engine fan clutches make strange noises when they let go, alternatively see if the fan is hitting anything when it turns.

Link to comment
Share on other sites

Leaking exhaust manifold.

its either the manifold its self or where the turbo bolts onto the manifold..

Check to see if all Manifold studs are there, esspecially on the rear.

And look to see if there is any carbon around the manifold..

had Same prob, common thing sposably..

agreed... if the turbos are still performing well and not dropping much boost, then i'd say this is your problem. happened to me as well.

Link to comment
Share on other sites

hi guys,

i haven't yet taken her in to be looked at (work issues). but i'm coming round to the idea of a leak.

when i dropped it off, my two complaints were that:

since they'd tuned my new powerfc, the car had been running very rich (400 kms per tank, whether i floor it or drive like a granny - 520kms per tank with my old mines computer). he said the original tune had been fine, something else must be doing it.

second, at idle, she frequently 'hunts' (revs by itself).

so i guess it could be a leak somewhere?

Link to comment
Share on other sites

sounds like your BOV might be giving you some strife. its a common problem, nothing to be too worried about. i dont know the reasons behind it happening, but it does happen. Bullet32 will know the answer... (he saved my baby!)

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Big claims here.  Any links up on the website ?   
    • If your HP goal is reasonable and you are not drifting. Buy a new R34 box.  If the above is not true, buy a wrecked R33 box and put a gearset in it.  CD09 are not as strong as you think and the cost of / mess around of the conversion puts you in gearset territory.    Also the deal above is awesome,, get that  
    • Just got back from a little hands-on with a G58 Baron....I was thinking about this... ..best I can figure it, that pinny was tail-ended ...I didn't really think about the wiring, because all that mattered was the tank and pump cradle (I think I mentioned the pump itself I couldn't vouch for)...which didn't matter, as you said you'd be replacing the pump anyway.... ...'for some reason'....and I imagine this is the panel shop's doing... they've replaced the cradle wiring with a metre of 7-core trailer loom, and attached the loom plug (from a different car) to that. The actual cable run from the top of the pump cradle, to fuel pump harness end in boot, is maybe 60cm in length...so I've no idea why they did this... ....the connector in the boot of the pinny, is not going to help you here...because in theory, it should still be present on your car. On top of that, because they've done what they did, we have no idea which colours of the trailer cabling, have been connected to what on the fuel pump cradle (pump +/- , shield, fuel guage/low-level senders)... ...this means, best approach is to remove the pump cradle, and re-work it now ...not later. That is, if you were going to replace the pump, do it, replace the soft lines at the same time...and sort the wiring out (replace that trailer cable with the wiring loom off your old cradle)...
    • Well, maybe not. The main feature of Chinese manufacture seems to be incredibly variable quality, coupled with an apparent willingness to find a way to see even the stuff that fails QC. So the military could still take the cream of the production run and somehow sell the "sellable but not really useable" stuff to the stupid round eyes on the other side of the world.
    • Have you adjusted the clutch pedal rod? You can wind it in to shorten it. Just can be a cnut to get to.
×
×
  • Create New...