Jump to content
SAU Community

Did Aac Clean And Idle Reset, Still Not Fixed?


skyliner1
 Share

Recommended Posts

Hi,

did the aac valve clean and reset idle, but still havin a few probs.

the stalling at lights has now all but gone, so result there.

but the idle still hunts, between say 700 rpm and 800rpm? according to the power fc hand commander

seems worse when lights are on.

is this hunting worse with other owners cars, or about the same and i've not fixed the problem?

does anyone have any ideas?

all help greatly appreciated and will mean less dents in car :(

thanks for looking

Link to comment
Share on other sites

I think it is quite normal that the idle will vary slightly. It's not really noticeable when watching the tacho, but when you see numbers changing, then it becomes obvious.

The fact that it is worse when the lights are on - which means the engine is under more load trying to drive the alternator - suggests a possible problem with an aging battery.

Link to comment
Share on other sites

I think it is quite normal that the idle will vary slightly. It's not really noticeable when watching the tacho, but when you see numbers changing, then it becomes obvious.

The fact that it is worse when the lights are on - which means the engine is under more load trying to drive the alternator - suggests a possible problem with an aging battery.

Thanks, i have been thinking perhaps battery or alternator, just dont wanna go spending a load of cash on bits that are ok, battery has been in car for the three yrs i've had it, so maybe time to change?

also have hks turbo timer fitted which reads voltage, seems to vary quickly (3 times a second or more) between 14.2 volts and 13.78 ish, would this point to a duff battery?

thanks again for the info m8 :D

Link to comment
Share on other sites

i cleaned my afm and acc valve aswell..

but now no stalling

no hunting wen car temp is normal..

the only problem..now is...

it hunts wen cold..

wen i start the car on in the morin it pretty much sits on 500rpm and loks and feels lik it gona stall

it like my cold air idle valve needs a clean..

has any1 cleaned that??

but wen at the lights or sopping it starts hunting

but wen it hits normal car temp..

its complete stops

nothing!!

any ideas..

Link to comment
Share on other sites

i cleaned my afm and acc valve aswell..

but now no stalling

no hunting wen car temp is normal..

the only problem..now is...

it hunts wen cold..

wen i start the car on in the morin it pretty much sits on 500rpm and loks and feels lik it gona stall

it like my cold air idle valve needs a clean..

has any1 cleaned that??

but wen at the lights or sopping it starts hunting

but wen it hits normal car temp..

its complete stops

nothing!!

any ideas..

not sure about the hunting when cold, mine still is ok when cold, someone must know tho' ??????

any ideas folks

Link to comment
Share on other sites

Is it just when its cold? Ive heard unless its really well/extensively tuned, alot of cars with PFCs have a poor cold idle which is one of the reasons why people wish to retain original ecu and have it chipped (to keep cold tune) or add a piggyback

Edited by Jmaac
Link to comment
Share on other sites

  • 2 weeks later...

i have got an power-fc...lol

yet anyways..

but i do u a apexi neo controller..

could this b why?

its hell weird..only wen cold does it hunt..

other than that its perfect ay..

plus i got an atmo bov too..

but i dont think that could b the issue..

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • So next year I am looking at upgrading from my VE SS bomadore ute to something more refined.  I wanted to stick with a V8 but not anything German or Australian, either a coupe or a sedan. So if I wanted anything newish that limited my options to either the Lexus RCF which I quite like. But with the price they demand and a kid on the way a 2 door coupe is probably not going to be the best idea. The next best thing would be the ISF but the newest models are 2014 and commanding over 60k and even the older 2008 models in ok condition starting around 35k is kind of bullshit. So I figured if I could not have the noise I could perhaps make do with easy power. Enter the infinity Q50 or Skyline equivalent. The price difference between the 300 and 400hp models seems a bit crazy. Right now there is 300hp Q50 one on carsales from a dealer with 61km for 27k drive away. If I wanted to get a 400hp Red or 400R car the prices seem to start at 43k From my limited research it seems that the only differences are that the 400r/Red Red runs more boost and a more aggressive tune. There are are turbine speed sensors on the turbos. Has 2 pumps for the water to air intercooler. Runs an engine oil cooler. I'm guessing that the exterior trims might look a little more sporty as well. I had a lazy look for upgrades to bridge the gap on z1motorsports They have kits that upgrade the water to air heat exchanger as well as the coolant pump which should give a non Red/400r better intercooling temps than the stock Red/400r. I added an engine oil cooler with a thermostat as well to try and make things as close as possible. Obviously the ECU is going to need a tickle. Having not done much in the way of research they also sell a ECU flashing tool with pre loaded tunes that are supposed to boost the non Red/400R by 100hp which adds 1k USD to the cost. The total cost of the parts @ the current time including shipping and taxes worked out to be $4350 AUD. Personally I would rather get the car tuned on a dyno which would probably add more cost Assuming the worst that you got a workshop to install the new parts I would guess no more than 5 hours would be required in the worst case @ 5 x $150 per hour = $750 So the total cost could be around $5100 So for easy number 5k + 27K = 32k I guess that would leave some change left over to swap out the open diff and fit a LSD Any thoughts?      
    • Right, not sure why I thought it to be a lean spike. It might be fixable with modern card-style hot film MAFs which have some design features to avoid counting reversion flow but I've never tried it myself.
    • I did not realise this, I'll contribute more and earn my stripes and retry later. 
    • I'm only going to hassle you for posting links to images. It's against my policy to click links that could be some nasty payload. Sadly, you need to make 9 more posts before you can just stick the images directly in a post, unless @PranK sees this and bends the rule for you.
    • Hello,new to the group, I bought a R32 from auction recently, wondering if anyone knows the cars history, seems to have the usual go fast bits on it, plan is to do an engine swap- add 2 extra cylinders and 1 extra turbo. https://www.dropbox.com/scl/fi/i4rjmlzubjbwjtguh6f4s/IMG20241011140744.jpg?rlkey=q0lumm251377vknbqktfwrycq&st=7scvwx4e&dl=0 https://www.dropbox.com/scl/fi/ro24qmwzlczzlfsr4y05x/Screenshot_2024-10-10-10-49-23-90_9a2f5bb2149dae94cd1e190effc09b33.jpg?rlkey=oyguh26ttshlf04ccp48odf4v&st=xloae97b&dl=0   New to forums and posting pics, if links don't work, take it easy on me, 42yrs old and I tune carburettors!!  
×
×
  • Create New...