Jump to content
SAU Community

Drift Practice

sidewayssam

By sidewayssam,
in Events

 Share

Recommended Posts

sidewayssam Mentor

sidewayssam

Posted
  • Author
Posted

yeh well il be going, got the skyline booked in for tune in mourning at tenagah and gonna get few new sets of rubber tomorow, haha my dads going down aswell to drift the ss but i dont think they will let him as it has no tow points

Link to comment
https://www.sau.com.au/forums/topic/202814-drift-practice/#findComment-3600128
Share on other sites
sidewayssam Mentor

sidewayssam

Posted
  • Author
Posted

mmmmmmmmmm i not 100% sure i can get down now :) i took slydr to tenagah to get tune and boost, they called me half hour ago and told me that whoever tuned the car last had locked the ecu so they couldnt tune it :) i then called xspeed who lst tuned it and they said it wasnt locked it just needed to be tuned on a laptop :( so then i called tenagah back and they might be able to do it by tomoro :D so hopefully its back tomoro mourning

Link to comment
https://www.sau.com.au/forums/topic/202814-drift-practice/#findComment-3601073
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • r34lad
      r34 starting problem

      By r34lad · Posted

      https://www.efisolutions.com.au/coolant-temperature-sensor-bosch-180sx-s14-s15-r33?gad_source=1&gclid=CjwKCAjwzMi_BhACEiwAX4YZUHsCQhbiDT_NC3q5wD9jrzH6Dts9eGSr19NXSDw7x9WVm1sH7G3S4hoCwaUQAvD_BwE this is the one i replaced today
    • r34lad
      r34 starting problem

      By r34lad · Posted

      I have replaced the larger coolant temp sensor, i do see a smaller one next to it (looks to be just 1 pin) but i assume that is just for the dash? or should i replace that aswell?
    • dbm7
      r34 starting problem

      By dbm7 · Posted

      Check coolant temp sensor ~ symptoms fit the hard hot start/cold start OK scenario --- if sensor goes open circuit, ECU thinks engine is cold and enriches mixture ....works when engine cold, but floods them with rich mixture when hot (Hyundi MAP engines are a bit infamous for this)...
    • Duncan
      Neil's R33 Gts-t Build

      By Duncan · Posted

      OK, starter changed for a spare without much trouble. Neil had kindly left space to get to the top starter motor bolt from above with a long spanner which makes the whole deal much easier, and everything else was neat and easy to get at from underneath. Once the starter was changed everything was good, unplugged the CAS and turned the motor on the starter to make sure everything was free and happy. Onto properly priming the oil and first start. I'd picked up one of these oil prime kit from Boost doc a while back and this was my first time using it.  https://boostdoc.com.au/products/engine-oil-prime-kit?_pos=1&_sid=28c628a65&_ss=r While I'd organised all the fittings to hook it up to my GTR (sump plug to -6 feed and -4 T to tap it in and retain the oil pressure gauge, neither suited on this car as the oil pressure needs to T into 1/8 NPT not -4 and the Aeropro sump has some massive drainplug not that factory whatever it is. So, waiting for a couple of fittings, then I'll prime it and do first start, hopefully next weekend. Other than that going well, there is very little stopping a final alignment, tune then shakedown day
    • r34lad
      r34 starting problem

      By r34lad · Posted

      Also to mention, i just tested the CAS, seems to be working fine, can hear the pulses inbetween 0 and 180 degrees, another mention aswell, when i let the car sit for about a hour today, i went to start it and it almost fired on first crank, then just completely struggled. Could it possibly be blocked injectors?, maybe allowing a little bit of fuel to seep past allowing it it almost start first crank?
×
×
  • Create New...