Jump to content
SAU Community

Recommended Posts

hi everyone,

just wondering if anyone can help me out.

i have a r33 gtr with these mods, and just wondering what times should the be running what else do i need to get into a high 10. also whats sort of boost should i be running???

cheers Tom

blue printed bottom end

Aries forg pistons

2 x hks 2530 turbines

n1 oil pump,

nismo 5 layer steel gasket

reco head

ported exhuast manifold

custom twin dump pipes

hks exhuast

Exedy heavy duty clucth

nismo short shift,

microtech computer lt8

trust twin entry intercooler

Arc intake air box

Tein full adjustable suspendsion,

Denzo 700hp fuel pump, , full nismo

oil catch can

sard 666cc injectors

g-reddy electronic boost controler

Link to comment
https://www.sau.com.au/forums/topic/204515-just-a-couple-of-qs/
Share on other sites

Cheers,

I asked the guy before they put it in and said it was good for over 300kw and my car is making 293kw ??? thanks for that

Yeah but for how long?

My car has one of those clutches. It's pretty much garbage compared to a decent twin plate.

Also what RPM should you launch an r33 gtr at to be on the safe side???

"Safe side" (assuming you mean from the mechanical sympathy point of view) and 10s 1/4 times are contradiction in terms. With the power you have a 10s is possible only with good tyres and a very hard launch.

I need to launch at ~6k to prevent bogging down, but this obviously takes it's toll on the drivetrain over time. Clutch failure is the most obvious liklihood, but gearbox failures also aren't unknown (particularly with a hard change into 3rd).

I didnt think 300rwkw was enough to do a 10 in an r33?

Same here....

the hardware sounds up to it but it seems as if you need a better tune to free up some power, or maybe the 293kw run was done at 12psi or so :P

well you lose more power with the all wheel drive and the gts-t is lighter but its no good if you dont get the power to the ground. but im not going to say anything because i dont know for sure. Thats why i asked, i would like to know. theres not alot of GTR where i live.

ok sorry about being a little short, but there have been a lot of stupid questions lately, and sometimes innocent ones get put in the same basket.

awkws are better, because if you disengaged the fronts on a R32 GTR with 300awkw you'd end up with 320rwkw - 330rwkw.

BUT you'd also lose 35% of your traction.

You have the hardware, simply get someone that can tune and crank her up to 350awkw and run some 10's :P

If it helps, with 280kw @ all four, I run a 11.8 @ 117mph in my R33 GTR.

I've now got 318kw @ all four and am running next Wednesday. I'll let you know how I go, I reckon 11.5-11.6 :D

I reckon you'll need 350kw @ all four to run a 10 in a R33 GTR... minimum :P

What boost are you running?

Edited by TommO

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Oh, that's grim. Something bad has been happening there.
    • Put an endoscope down the hole and saw this. Not quite all around the bore but a good 60% at least. Chin to the chest and towards further disappointments I guess.
    • 2 does "sort of" applies, maybe......but looking at what parts would be needed for the swap to get engineered, registered, and insured, and basically that's everything under the car, the modifications the make it legal would be problematic and horrendously expensive, all for a street car that just cruises around and hits a few twisty roads on the weekends Also, from looking at the NSW rules and Regs, with all modifications that is required just to make the car safe and not twist itself to pieces, and then actually get registered for street use, may still be impossible nowadays As for 1, when you add in a fresh engine, fresh transmission, rear cradle and diff, tailshaft, suspension, brakes, cooling, and all the other fabrication required, your probably looking at up to $100k to do it right, all for a 20 year old MX5 that is over engineered and you would never be able to actually use the power it has on the street, much like your beastie, which I love, but you actually track that thing and can use all of its powers in anger, in a safe environment  Hell, the old Bogan Cruise Ship had more power than I could use on the street, and in hindsight, I went a bit silly on that thing, it didn't really need the 500hp it had for what I actually used the car for, it was fun, but basically unusable on the street if you value your licence  As for cams, yeah, I'll probably book it in for them to get installed and tuned soonish, like next month after MX5 Mania are back at work....... and yes, I've already sent a email to bin the turbo quote and quote instead to install cams and a new Fluidampr balancer that will suit the 2.5 better than the OEM 2.0 balancer that is swapped over for the 2.5 install, as the balancer needs to get pulled to time the cams it's a while your in there sort of thing I did think a bit about flex fuel for a laugh, but being na, and no where really around locally anymore to get E85, I've binned that idea, so no sweet sweet corn smells are set for the car I wish E85 was more of a standard fuel, it's better for the environment, better for tuning, plus that sweet sweet smell we all love As for fitting in the family, that's not needed, as everyone in the family already owns a car that can seat 5 humans comfortably enough, the MX5 is "my toy" As for buying a car that is already built, nah, I would rather pick and choose my parts, I enjoy the process, and in the big picture, the additional cost is well worth the enjoyment, and the occasional frustration, I get out of doing it, albeit with other people spinning the spanners, and me, just paying the invoice 🤣
    • Excuse me, but 2) does apply 1) Would also apply if you consider how much is spent in the alternatives. Also there's the option of 3), buy one pre-built that you can put your family in (it's me, it's my car)   That said, I went on a ~500km drive the other day. I didn't use anything more adventurous than 3rd/4th gear at about ~3000RPM and 50% throttle and I was going as fast as anyone has any sense doing on a public road, with enough grip to the point where I didn't want to go any faster. I was obviously under the limit of the current car etc etc. MX5 with 2.5 N/A to achieve the same speed would be more fun for any road scenario. Maybe consider cams. I wouldn't boost it. The use case is just not there and it won't actually make the car more enjoyable unless you really do plan on wringing gears from 1st to 3rd (at least) at 100% WOT on a public road to 150+kmh.
    • Great if: 1. You had all of the money for everything else that is required  2. Lived in a country where you could actually do this and drive it legally on the road Sadly, neither applies to me As for the turbo, I am having second thoughts, mainly for engineering/registration legality reasons and insurance  Not saying I've finished doing stupid things that I probably should do to the MX5, but boost, and V8 engine swaps isn't on the cards Strange, but true 
×
×
  • Create New...