R32gtr Pfc Check

[NisGTR]

Hi there i just want to check if everythings in order.

Ok I’ve installed my Apexi PFC along with my hand controller, I’ve gone through all the procedures with the English translated manual. I allowed my car to idle for 30mins before doing anything, the idle was pritty good, it started at 1200rpm and dropped to 950rpm. I did a sensor check during the idle and all these sensors were on. IGN,IDL,NTR,ECC,O2H and the ones that were off were. STR,A/C,PWS,WRN,FP1,FP2,ACR,FAN. After doing that I turned on my AirCon for 10 mins, and then my demister for another 10mins, all sensors were still good. After I followed everything I restarted the car acouple of times to ensure the engine was stable and it was, but the only thing now is the idle sits at around 1100-1000 but doesn’t jump, is that right? The KNOCK Monitor sits at 1 bar and when I give revs quick it jumps about a quarter of the way, and when i give it slow revs it doesn’t jump so much. is this normal? Thanks

Please get back asap.

[Topaz]

Knock shouldn't jump with revs when the car is idling, mine doesn't but then again I have never had problems with my PFC.

It's not uncommon to see high knock when the car is initially started, it just needs to then be rest to 0 in order to read the knock whilst driving the car..... Taken it for a drive yet? I think the PFC 'learns' AFR's and the such as well so it's good to drive it easy sometimes and hard others.

[NisGTR]

yep I've taken it for a drive today knock goes up to 29 on full load at 5,000rpm, but stays stationary on the highest number value. But the knock doesn’t jump when the car is idling and only shows one bar on my PFC.