(adelaide) R31 Skyline Wagon
Announcements
-
Similar Content
-
Latest Posts
-
By Prof_Finesser · Posted
Ok I checked the fuse it’s good but I’ll check the rest in the morning thanks for the info gonna hopefully figure this out tomorrow I wanted to do a first start on this built rb but gonna have to wait -
By joshuaho96 · Posted
Have you checked that the starter signal fuse hasn't popped in the fuse box? This is the simplest thing to start with. Then verify that your ignition switch is providing a low resistance path from pin 5 to pin 1 when the ignition switch is turned to the start position: I misspoke earlier about the starter motor being ground switched. Technically going by the circuit diagram the solenoid is always connected to ground and actually you have to provide +12V to it via the ignition switch to power it. If you have confirmed the switch is working normally then you're down to a wiring fault and you have to chase the signal wire from the harness back into the cabin. Most likely it is the Wiring Specialties harness. I have gotten mis-wired harnesses from them before. -
Bleed it again with the engine running.
-
By Prof_Finesser · Posted
Yea I checked it’s at 12v but I’m not sure what else I can check? -
By Prof_Finesser · Posted
Ok will try that tomorrow morning but wouldn’t it have 12v all the time because it’s connected to the battery in my case
-
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now